Fix Your Low Oil Pressure in THREE Hours for THREE Dollars by watching this THREE Minute Video. 

I didn't drop the pan on this 4X4. I did it from the front by rotating the bracket that holds the o ring. It was about 3 hours start to finish.

​@@bruceyyyyy hello bruce,did you have to prime the oil pump when you replaced?? Im scared to put everuthing back until i figure out about how to prime the easiest way

@@jeremyjones8872 I did not.

@@bruceyyyyy i got pump replaced and went to start and truck had no oil pressure so was told it had to be primed so after spending over 2k in 3months with 3dif mechanic shops i tried doing it myself but now i dk how to prime easiest way and have no faith and $ to hire another mechanic and its my only vehicle and its used for work truck so im beyond frustrated,.any help u can give on priming orr i would greatly appreciate it bruce

@@jeremyjones8872 It looks like there is a service port on the side of the block that can be used to prime it.

Yes the o ring was the culprit. This is a 5.3 V8 so I'm not sure how helpful it will be for you.

Mine wasn't ticking. Just had very low oil pressure.

​@@bruceyyyyy thanks

So I didn't need to drop the oil pan

It was to move bolt from lower mounting on pump to upper side, easier to install

Mine came right off with an M18 impact. I then removed the pulley with a puller and reinstalled it by heating the balancer up before sliding it over the crankshaft.

@@bruceyyyyy I have the M18 impact. I only have about 60% luck getting things off. End up using the breaker bar a lot. Some say it’s the 5.0 battery. I’m not sure.

It definitely does better with my 9/12AH batteries but it gets heavy with those.

Thanks, I guess I'll already spend over 3 days trying to figure out what the problem now thanks to you, I know now what's is the problem is.👍

Yes the pump was removed and reinstalled.

A good shop not a lot with this method. But this isn't an approved method but any book that I've seen.

A mechanic wouldn’t do that 😂

I think the 4.8/5.3/6.0 are all the same set up.

I believe this procedure should be the same for the 4.8, 5.3, and 6.0

@@bruceyyyyy dont know how to send the link,youtube video title: LS Stock oil pump mod (stop wasting money on oil pumps)Dammit, it claims to give 70lbs oil prussure,not sure if that's a good idea but he thinks so.

@@eastside0434 I just replaced the pump since I had to have it come off. Was around $100 for a high pressure version. I get around 70 cold and around 50 hot now according to the factory gauge.

Fun fact: 3 minutes and some seconds is still 3 minutes according to the National Education Association

@@bruceyyyyy I trust the knowledge base of the public education system

Maybe on a 2WD. Dropping the entire front end doesn't seem easier with this being a 4WD.

GAMBLEST!

Yes. Common issue with age.