Full delete with HSP Y bridge, intake, turbo mouthpiece, hot and cold side intercooler pipes. Sinister up pipes magnaflow downpipe and air dog 2-4G lift pump. Will do an update video of the delete and current mods in near future.
Yes installed EFI live tuning at the time I did all this work. Unfortunately that has become much more difficult 2 find thanx 2 our friends at the EPA cracking down...
What did you do with the o2 sensors that were connected to the oem exhaust. Do you zip tie them out of the way? And how has the straight pipe from eBay holding up? Is it the same quality as the expensive ones? Thanks👍🏼 sorry for all of the questions
With that kit did they give u a extra piece of pipe for the options of running straight pipe or is it strictly just a muffler setup? Or do u have to buy that piece of pipe separate.
The kit is designed 2 fit short bed and long bed trucks. I have a 6'5 bed so it was just an extra piece. Just so happens its same length as the muffler so that's exactly what I did is swap the 2 and now I'm running straight pipe🤣
No cutting but the ends are flared 2 fit into one another since the 2 ends of the pipe were designed 2 fit inside the muffler I purchased a small double flared adapter 2 link the 2
Lol glad u got a laugh..if I remember correctly I unplugged them from where they fasten 2 the harness running along the truck. Just a plastic plug/clip No need 4 them in the system I used
Probably a lot of mixed responses 2 that question and a lot of opinions. I personally feel the flo pro system is superior in design and ease of installation. Performance wise u probably gain nothing with 1 over the other but especially if installing yourself u will love the flo-pro
Hey sorry, came across your video again 😂😂 question... when you take out your old exhaust and put the new one in... do you have to plug the temp sensors into the new one? If not, do you just get a tuner that will block out the sensors?
Turners Speed Shop oh sweet! I thought it would be hard doing it on your own if I had to re use the sensors, but if I don’t need them then it should be easy plug n play
I did a removal video of the factory exhaust as well. Just disconnect and remove all that garbage, installed new system in about half hour. Tuned the truck and good 2 go. Took longer 2 remove the factory garbage than install the new system
Check out my other videos for exhaust tip install & review. I did not purchase kit with tip, went a less expensive route. However flo-pro has numerous system options
@@Turnersspeedshop got any videos? Talking to guys half of them say no drone at all and then some say it's terrible 😂. Got a 5 inch with no muffler ordered, and I have no idea what to think at this point.
I'll see if I can do a few clips..hard 2 get audio 2 grab the drone effect...I like the tone, I enjoy it loud and driving around town no real drone or issue but pulling a load at 60-70 my ears are a bit numb after 6 hours 🤣
@@Turnersspeedshop yea that would be awesome. But yea frig I don't know much weight, but usually towing something and I don't wanna go deaf, but I really want that 5 inch tone.