Very simple process mechanic skill level 1 being low 10 being high, I would say this is a 1. It comes out the same way goes in. Hope the video helps,and God bless.
Hi Luke, I wanted to take a minute to let you know I'm a big fan of your videos and appreciate the time you take to share them. Always informational and inspiring. I use many of your "tricks of the trade" everyday. Keep up the good work and Good bless!
Ian, Thank you, you made my day. I very much appreciate your kind words. Please Let me know if you have ideas for future shows, your advice and tips would be greatly appreciated & I hope to get to know you better in the future. I would like to make an advisory board in the future, of good like-minded Christian men. To make sure the program is going in the right direction. Thanks Luke
That sounds like a great idea. As far as future videos go, I think a video on your trucks would go over well. I'd love to see some of them as I am also a Ford guy and we have some similar trucks.
Is this the same process for the F800s? I tried to start my dump truck with the key out of our 84 F250. It did fit in the ignition but didn't turn. Are those the same key?
Luke Simons I see. I remember one of your videos a while back about how to keep your truck clean, just wondering what kind of truck that was, it looked like a HD Chevy from what I could see, thanks!
You could try any key that is a Ford key, see if it will turn, or a hook and pics that perhaps. If not you may have to pull the whole mechanism out of the dash, which on screws from the front.
The face on screws from the dash. There will be a small slots in the face, take a flat screwdriver with a hammer and push the slots left do you Lucy righty tidy. It will come off. Then after that you wire it back in and put it back in the same way It came off.
