Great video, i managed to rebuild a f80 RL with that video. Thanks you saved me a lot of money. To all the haters down in the comment section: there's no comment on the video needed all you need is to observe the service once otherwise there's something wrong with you.
Thank you it helped me a lot, to service my fork fox F90 RL, I didn't figure out how to put out from the body of the fork the damper. Keep up the good work!
So, the damper service is essentially just replacing some O-rings? Also, what type of grease were you using to lubricate the Damper Cartridge prior to the reinsertion into the fork legs? How about a video for Air Spring maintenance? Very good video for showing the steps involved! Probably the best one I've seen on YT. Thank you for sharing this!
Great video, I got a rebound knob stuck after removing and installing the damper. Didn't take damper apart yet, just did a cleaning and oil change. What could be possible route cause ?
When should you perform damper service on your fork? I have a 32mm 2011 fox float 100RL. I'm about to replace the seal, so I thought while I was at it I would clean the uppers/lowers, put in new oil, and regrease the bushings. Should I go ahead and perform the damper service?
Hello thanks for the video, a question. How much oil and what type is inside the locking mechanism? It would be great if you put descriptions and quantities to your video Thanks
Hey there, could you put a link of the Service Kit in here? I want to ride my brothers old Mountain Bike, which hasnt been moved for the last 3 years. The damper is a fox 32 f100 and looses some oil on the tubes after sagging in. Thanks :)
Buenas bro, en la página de Fox, dice que lleva aceite de 7w. Yo tengo la misma horquilla y dentro de poco le haré mantenimiento, pero yo voy a utilizar aceite de 5w para que sea mejor la sensibilidad. Ahí estás tú cuál prefieres ponerle. Saludos