I’ve got a couple presets worth of stuff in here on different channels. Both amps on channel A is my standard AC20 / Band Master. Both on B are just fatter versions of both amps. Both on C are my dual Bad Cats. D is a Bassman I sometimes pair with something else. In the cab block, I was using B or C usually. B should be “Go To” left and right and C is dreamteam, which has Golds blended in. The preset comes with the IR’s, you just need to pick where they get stored in FM9-Edit. I'm currently digging my DynaCab settings in channel D, which is where it's saved. My reverb before the amps on channel A is my Wet reverb type thing. B and C are cloud-like sounding things. B on my first drive is a fuzz that I like to use with Comp channel B for slide stuff. B on my 2nd drive is a SuperBolt and C is a Morning Glory. If you want to try my Layouts/workflow: I basically just make a Scene per song. I choose the Scene and it goes straight to the Effects Layout with the tempo and effects I need for the intro ready. Then I just turn stuff on and off as needed and then next Scene. Works well for me live. Easy enough to setup. EFFECTS: Drive 1, drive 2, analog delay, tape delay, pitch, solo (control switch), chorus/vibrato, pre-verb, ambience (control switch) Holding drive 1 and 2, both delays and pre-verb changes channels for those effects. Holding Solo goes to Scenes Holding chorus/vibrato goes to View 2 which has: Comp, tremolo (control switch) and tap/tuner Solo engages the Fat switch on both amps and bumps the volume a touch Ambience of “AMB” makes the post reverb tail much longer. It may also make the delay feedback longer… don’t remember. The tremolo switch ramps up the amp trem.