Front Runner base deck fitting for new Suzuki Jimny 

Helpful video! Though I think it would be better if Front Runner made it higher---at least as high as the bottom of that 12v plug. That way you can store/install more things underneath like a battery, an ARB compressor, valuable items like a laptop, etc. Just put hinges on the board for access to the floor and then install lockable cam latches or compression latches that are flush to the floor. You can also screw in some e-track tie downs or those flush/retractable tie down anchors in key corners and just have a couple of e-track ratchet straps handy in case you wanna tie down anything.

tks for the video West Hghland MicroAdventures! It´s a great idea to put a hinge and make a small hatch. Also, FR could do a version that make possible to maintain one of the rear seats.

Unfortunately you can’t you have to carry it around in a separate bag. I’m going to look at adding a hinge to the back section so I can continue to use the jack space. Alternatively you would have to travel around with the Allen key fitting and take a deck off (6 bolts) Hope this helps

Hi Im from Greece I have Jimmy Lcv (with no seats) is it possible to find seats and belts ( Suzuki here doesn’t sell ) 🙏 thanks

Looks great. When you lay your front seats flat, is the base deck pretty level with them? I’m looking at sleeping in my Jimny and an even surface should work a lot better. Thanks.

Where i can buy one of these? Looking for jimny 2010

Hi. Great video. Is there any issues with the vehicle alerts by unplugging the sensors when you removed the rear seats?

how do you access the jack and tyre lever?

Hey! Another question Wondering if you might be able to get the dimensions of LxW of the jack area (the styrofoam area, and the height from the bottom to the base deck? I have a shop in Australia that wants to fabricate a mount and lithium battery for that spot for a dual battery, and my Jimny is a few months away.

What did you end up doing with your seat belts? The instructions from Front Runner say to bolt them to the middle bracket, but I'd really like to have them out of the way.

I noticed in your video you did not put the 2 bolts back for the seat mounts and they have been kept open. I would advise you close it off with the bolts that you took out. 1. it will ensure no water and dust ingress into the car. 2. you wont loose the bolts.

Would it not have been better to trade your Jimny in for the New Commercial Jimny and save you the trouble fitting this kit. Also as yours is a Four seater version it would have been a much sort after Jimny and sold for more than you paid for it by about 25% as there are not many in the country and the cost is increasing all the time, because of the new emissions laws affecting the new Jimny Four seater and that's why the Commercial is the only new Jimny you can buy in the UK now.

Hey! Are you able to let me know what the measurements are for the base deck, please? Front runner isn't able to get them for me. I'm specifically looking to know what the length is from the boot end to the opposite end of the deck (from the middle of the deck) and what the length is from the cutout section on the side to the opposite end of the deck, if you get what I'm saying! I need these to figure out if my fridge will fit. Thanks!

Get a tripod!!