The two of you should be very proud of your creations. The amount of time, effort, and detail that you put into each piece is absolutely awe-inspiring!
What bars were used… is the older/wiser guy using a stock bar or larger tip carving bar…sorry don’t know your names. Great vid thanks..like the music too!
Older and definitely wiser guy is Paul and younger good looking guy is Jacob Lol The bigger bar on the 562 is Cannon supertoonie. It;s like a narrow stock bar. 3/8 LP sprocket and chain
Onsight carving like average around $2500 . depends on location type of wood . They will last for years if taken care of. I have some well over 10 years old. They last even longer when removed from the ground.
Awesome job guys!! Beautiful! I have a question though... That flap sander you guys used in the drill, what is it??? I think I need to invest in one... Where do I get one? Thanks! 😁✌️
@@CarverKingsOfficial Thanks a lot , i enjoy sculpting in wood 346 XP & 562 XP was on discount and i bought both of the saws.346 with 18"bar pulling .325 chain and 562 with solid nose 20" bar equipped s with 3/8" chain.346 responded acceptable to old old chainsaw carving habits but with the 562 I was about to come close to eat it in the middle of my face for a few times so I was looking for a solution to make this saw usable I am not carving mostly doing some abstract work without too much tricky cuts but still it's better to change that solid nose logging bar i guess.Thanks a lot.
@@K1To749 Great saws. Oh my yes need to be really careful. I use the cannon supermini with 3/8 low pro. But still have to be carefull and use proper technique when cutting with the tip