Futaba Simple 4ch Programming w/ Dual Rate and Expo 

I tend to agree that positive expo made the sticks more sensitive. Should have added negative expo to make the center stick area less responsive. Oath wise well done and just what I've been looking for. Positive expo is used on Spectrum transmitters. Confusing isn't it.

Good tutorial, all except when you set your expo. Think for Futaba to soften the feel around mid stick you have to go the other way around, for example 65% expo should’ve been at -65%.

Thanks for the tips. I had been searching for the expo and had no idea it was in the dual rates.

Thanks for the video, it was really informative! By the way, to set triple rates it's actually pretty easy. Just select the same switch on number "3" at the bottom on the dual rate menu and that will work! I think I'll be building this plane!

Thanks for the walk-through and succinct explanation. I'd like to see you do more of these ... in fact how about a 'how-to' series on the 14SG!! Well done Kevin!

i would have liked to see a set up at the beginner mode on your 3 d switch. very helpful video none the less

I found that positive made more sensitive negative was less sensitivity.I think that maybe incorrect what you show on video.

as I stated below 6 months ago then forgot -- futaba expo works opposite to others so DUDE the EXPO you set up is wrong. It should be set to negative values not sure how you didn't see this it's a visual graph... besides that -- thanks again ...

I believe you're using the expo wrong to soften the sticks in the middle on a futaba its negative expo not positive

The EXPO works opposite than shown in the video!.. I don't understand how an "expert" flyer does this mistake in a video!

Thanks for the help with setting dual rates, the manual is rubbish. 14SG is a great Tx but settings are over complicated, you have to go a long way around to do a simple setting. Thanks again.

Fantastic. Thank you for your help.

URGENT READ THIS FIRST - 5 years later this video has NOT been corrected - although it is super helpful in setup of the 14sg, the EXPO setting is STILL WRONG-- it MUST be set using NEGATIVE (-) numbers to make the stick softer around the centre- that is how Futaba works, not just the 'old' Futaba as the author claims. To check this, simply look at the curve in the radio in front of your EYES. If you know how graphs work, that will confirm it.... The info re expo in this video can cause beginners to CRASH!!! PLEASE CORRECT IT. TWO things to remember when using Futaba - THROTTLE is ALWAYS reversed, EXPO is ALWAYS negative unless you want to make the sticks MUCH more sensitive around centre - otherwise, thanks for all your advice, the rest of it is perfect :)

Shouldn't you use negative expo to soften around the joystick centers on a Futaba? I'll bet the maiden flight was exciting with that setup! Also, did you figure out how to get the 3 position switch to give 3 flight settings? Thanks.

excellent! thanks!

how do you setup duel ailirons

Thanks for the tips. It was helpful.

I have a T14SG and also have 3 planes, but every rx are linked on each model, so no matter what model I have selected, if I turn on two planes or three avery single plane have signal at the same time. what can I do to avoid that ? please help!

Futaba its negative expo not positive

Hi Can you please share setup for Flysky transmitter ?

Exponencial set up, is wrong.

Need to calibrate the throttle!

How to set up flaps in 7 fastt channel reciver

How to resolve futaba backup error please update me

Sorry but your expo is not correct. what you've done is made the aircraft a lot more sensitive with the stick throws... check again