Very professional and simple teaching pace that enable every airgun user to understand the bits and pieces of their gun and understand how things work. Thanks Ernest and please convey my appreciation to the whole FX team.
Hello I have a new rifle FX Wildcat MK3 BT Compact cal.22 For cleaning reasons, I removed the barrel from the rifle by COMPLETELY unscrewing the two screws fixing the barrel of the rifle. On the official FX Airguns drawing, those two screws have references FX19086 (conical grub screw M6x8) and FX19955 (grub screw M8x6). The FX19955 screw (grub screw M8x6) had some dried glue around it: I cleaned this dried glue completely. I then reassembled the gun barrel and screwed the FX19086 (conical grub screw M6x8) and FX19955 (grub screw M8x6) screws. Since then, every time I fire, the air under pressure escapes from the screw FX19955 (grub screw M8x6). Should I put glue around this screw to avoid leakage? If so, which one? Could you help me Vincent (from Belgium)
Hi Ernest, Great video as always very informative, my question is I have the later MK3 with the brass bodied amp reg where you can remove the reg without stripping the whole of the reciever to to access it, is it possible to fit an in reciever reg such as a Huma to get a double reg set up same as the bt version the Maverick and the Impact ?
I am having trouble with getting the sear back in correctly. The view of your video was not close enough, so I am a little bummed out. I will try and watch a couple more times. There are the 3 pin holes, to pin the sear, the pac-man assembly, and I believe you said a safety lock? Starting with the receiver upside down, the top hole #1-??, middle hole-??, and the bottom hole #3-??. I’m sure I am over thinking it. I know I should have recorded the takedown, that’s on my dumbass. Great video and I love my Cat III, but at this moment I can’t use it! 😭😭
Mine wont latch when cocking. Ill have to check for the 33mm and the factory grub screw marks. Maybe thats all it is. In 22 caliber its my favorite gun. Insanely accurate and quiet.
In the disassembly video you said to make sure the valve screw on top of the receiver only had a half turn on it. Is that literally, or did you mean to back it out half a turn?
Hi I have a question how do you adjust the length of the barrel placement in the block? I just got a wildcat mk3 sniper .30 and the brass sleeve over the barrel at the block is out to far and will not let the clip slide in. It's safe to shoot, had to hand load it to set it.
I have a .25 wildcat mk3 sniper the stock settings are 110 bar reg and on power stand 7 it shoots the 25.4 grain jsb at 277ms 63 joules 69 shots before refill. I use power 5 245ms 49 joules 115 shots very nice gun.
Just received my wildcat mk3, something is loose and sliding back n forth near the power wheel.. any ideas? Is this normal? I have no idea, but seems like it should not have anything rattling .
If so please contact our technician team for more detailed assistance. FX Airguns United States Monday - Thursday 9 AM - 4 PM EST Fridays 9 AM - 3 PM EST Phone: +1 866 639 0772 serviceusa@fxairguns.com If not you can E-mail Sweden customer service at Info@fxairguns.com
@@FXAirguns spoke to us tech support, when not cocked the free float hammer is the rattling noise. Once cocked, noise is gone. This is normal from what I was unexplained. All good. Thank you.