Garage Heater Install ― The Final Details

Подписаться 14 тыс.

Просмотров 4,4 тыс.

50% 1

In this video I close-up the wiring boxes, trim the zip ties, put the side back on the unit, plumb the unit in both directions, then make the diagonal bracing. On the sides, I make long braces spanning between the vertical drop legs, and on the front and back I make shorter braces that go between the drop legs and the bracket on the garage heater.
I cut all of the bracing with a cut-off blade on the angle grinder then radius the ends for a cleaner look and to keep things smooth. Everything was bolted in place with 5/16" hardware and split lock washers were used to keep everything tight. While I was installing these braces, I went over every nut and bolt on the hangers and made sure that every one of them was tight.
The heater itself is completely done, but I still have to add a condensate drain, wrap the thimble with a ceramic blanket then insulate the area around it, caulk the boot with high temp silicone, and eventually create an opening in the wall when that goes in to go around the flue. 😊
🍺 If you enjoyed the video, consider buying me a beer!: www.paypal.com/cgi-bin/webscr...
Propane/Heating
Mr. Heater 50,000 BTU Big Maxx - amzn.to/3G35gwH
Yellow Jacket Gas Pressure Test Kit, 0-35"Wc - amzn.to/3FXUzf3
Monster Thread Seal Tape - amzn.to/3EV24V2
ProFlex Gas Pipe (1/2" x 25 ft) - amzn.to/3gjIEis
ProFlex Gas Pipe (3/4 x 25 ft) - amzn.to/3VBL0cR
CSST Tubing Cutter, 1/4-inch - 1-1/4-inch - amzn.to/3SeuiNB
Pro-Flex 1/2" Brass Male Fitting - amzn.to/3yF9k3l
Pro-Flex 3/4" Brass Male Fitting - amzn.to/3D0gKRq
Pro-Flex 3/4" Union (Coupling) - amzn.to/3ezIWRP
Pro-Flex 1/2" x 1/2" x 1/2" Tee - amzn.to/3EGq2U1
Pro-Flex 3/4" x 3/4" x 3/4" Tee - amzn.to/3TcQqcI
Pro-Flex 1/2in Termination Plate 1/2MIP 3/8FIP CSST Male Adapter Fitting - amzn.to/3T3MkDq
Nylog Blue - amzn.to/3KNjtQI
We're also on Instagram: / planet_mojo
Please Share, Like, Comment, and Subscribe!
Buy me a beer: www.paypal.com/cgi-bin/webscr...
Click here to subscribe ― / @planetmojo
The Planet Mojo Website ― planetmojo.net
Thank you for watching Planet Mojo and have yourself a great day!
#GarageHeater
#ShopHeater
#HeaterBrackets

Хобби

Опубликовано:

8 янв 2023

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 18

@PlanetMojo Год назад

Now that the garage heater (furnace) is completely done (as far as the ceiling is concerned) I have a few small details above the ceiling level to take care of, then I can hammer away at the ceiling until it is done! As part of an upcoming video, I will test how much the heater will raise the temperature out there in one hour and two hours. I will repeat that experiment daily until the ceiling is done - possibly until the wall is done. It should be very interesting! Heating and Cooling Mr. Heater 50,000 BTU Big Maxx - amzn.to/3G35gwH High Temp Silicone Boot - amzn.to/3Cy6Tld Yellow Jacket Gas Pressure Test Kit, 0-35"Wc - amzn.to/3FXUzf3 Monster Thread Seal Tape - amzn.to/3EV24V2 1"x 12"x 24" Ceramic Blanket - amzn.to/3GKBy0b 1"x 24"x 32" Ceramic Blanket - amzn.to/3ilA443 ProFlex Gas Pipe (1/2" x 25 ft) - amzn.to/3gjIEis ProFlex Gas Pipe (3/4 x 25 ft) - amzn.to/3VBL0cR CSST Tubing Cutter, 1/4-inch - 1-1/4-inch - amzn.to/3SeuiNB Pro-Flex 1/2" Brass Male Fitting - amzn.to/3yF9k3l Pro-Flex 3/4" Brass Male Fitting - amzn.to/3D0gKRq Pro-Flex 3/4" Union (Coupling) - amzn.to/3ezIWRP Pro-Flex 1/2" x 1/2" x 1/2" Tee - amzn.to/3EGq2U1 Pro-Flex 3/4" x 3/4" x 3/4" Tee - amzn.to/3TcQqcI Pro-Flex 1/2in Termination Plate 1/2MIP 3/8FIP CSST Male Adapter Fitting - amzn.to/3T3MkDq Nylog Blue - amzn.to/3KNjtQI

@ccrx6700 Год назад

Looks awesome. Let's get some heat in there so you can finish the rest of the work this winter. 👍😊❤️

@PlanetMojo Год назад

I agree 💯- I've had soooo much distractions the last month, but finally got this done! And it turns out the weather is going to be very cooperative in the ten-day forecast 😊🔥🔥

@handydave Год назад

Great to see the heater installed! That should make the rest of the work a bit less chilly (freezing 🥶)!

@PlanetMojo Год назад

Thanks Grape! I tested it, and it will absolutely help for here on-in. I can raise the temp nearly 30℉ which is way more than needed. Every bit of ceiling from here-on-in will only make that better so things are looking up! 😊🔥🔥

@DickYoder999 Год назад

I'll bet you are relieved to be done with the heater! Congratulations on having heat (sort of 😉)!

@PlanetMojo Год назад

Thanks Dick! It is awesome to have the heater done indeed! I did a short test the day after this video was produced, and the temperature raised 30℉ in the shop, but I believe I could raise it 40℉ or more pretty easily! That's with two thirds of the ceiling open (basically no help retaining heat at all), and about 40% of the wall area uninsulated. That's pretty good, but it takes a lot of propane. 🔥🔥

@ShedHomePro Год назад

Good job Mojo! I'll bet you are super glad to be past the heater. That was a lot of details to take care of, but it all came together, congratulations!

@PlanetMojo Год назад

Thank you Shed Homes! I'll be testing it daily as I continue with the ceiling. It will be interesting to see how much I can raise the temperature with everything so open, and how it improves as I get more ceiling and eventually wall completed. It should be interesting 😊

@adenvet2830 Год назад

Hi Mojo, nice video and a great series, so onwards and upwards for 2023. Hopefully economically things will start to improve but I'm not holding my breath.

@PlanetMojo Год назад

Thanks Larry! We are worried about the economy in the upcoming year as well. One thing we will be doing to moderate high prices is buy freshly cut lumber from the Amish and drying it in our greenhouse. Time will tell about the pricing of the hardware, etc. Maybe we will have to revert to wooden hardware like drawer slides?

@RobertRalphR Год назад

I want to go back on the entire series for when I build my post frame. Is there a playlist with the entire series in it?

@PlanetMojo Год назад

There is a playlist for the heater install, but a lot of the propane line is in another playlist. I am thinking of making a playlist that goes all they way back to the moving of the propane tank and the running of the PEX propane lines all the way to the final sealing of the wall. It will be a long playlist, but people can choose wat they want to watch, and it will all be there!

@sharpshooternick 9 месяцев назад

But your way is better I might go to Menards for the 20th time this week. I originally was going to do the thread bolts , then my co worker said to get a mount Menards doesn’t sell those, then I had my own idea of 4 chains so I was gonna do that tomorrow but now I think ur way looks nicer

@PlanetMojo 9 месяцев назад

No vibration, so it is very quiet. Worked very well last year 😊