Garmin FishPro Transducer - Secure Top Cap with Screws per Garmin

Подписаться 464

Просмотров 3,6 тыс.

50% 1

Folks have reported issues with the transducer not working correctly because of fluid leakage. Even when the seal is replaced with the new and improved "red" seal, and the yellow ont discarded, there is still sometimes a probpel. Looking at the Garmin install instruction for their transducers in boats, one can see that they affix the top cap to the housing with some miniature screws. The top cap has holes already around the outside edge and these are the holes used for the screwu. Use @2 x 1/2" Self tapping SS Sheet metal screws. You will need a #1 or #00 phillips, becasue the screw heads are so small.

Опубликовано:

29 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 6

@jeremypai9993 6 месяцев назад

Hey Bill, where did you obtain those screws you have mentioned in the video, I can’t find them in mine local stores…, thanks.

@billjenkins1535 6 месяцев назад

BelMetric Online or here is a link from google ...www.fastenersuperstore.com/products/298704/self-tapping-screws?pid=17345

@michaelbrantley8892 29 дней назад

Instead of using a liquid to fill the housing void (anti-freeze), I used a $5.00 bottle of Ultrasound gel from Amazon. It doesn’t go anywhere, hell I didn’t even use a gasket. I placed the rubbery tube on the housing and left it open to the air as I pushed the transducer down allowing the excess gel to fill the tube. I then plugged the end of the tube and zip tied it to a wire bundle. This crappy designed Garmin transducer mounting system is now fixed. I used four screws instead of six.

@bradwylie9732 Год назад

Nice1. So annoying that the transducers are so shit considering the cost. Also those arrows point forward in the 22 trophy

@bradbultemeier4266 2 года назад

Hey Bill. Did you remove the side clips that sit on top of the transducer somehow? Mine have two clips on each side that sit on the top that prevent putting in 2 of the 6 screws. Also... did the screws solve your problem?

@billjenkins1535 2 года назад

I still have them on there. I used only the 4 screws. As to solving the issue; I do not know if it was the screws, BUT, what with the #1 screws, #2 the new upgraded seal ( the red one as opposed to the original yellow one, and #3 the removal and reattachment of the fluid tube that mounts to the nipple at the bottom of the body with a bit tighter zip-tie, and #4 the extension of the fluid tube up to the front where I tied it into a fluid reservoir ( all this stuff being in the series of videos) things have not given me a problem.