GCC: Shaker on site and testing the huina 583 upgrade 

Thanks mate, its nice to get some real world testing done with the shaker :)

Thanks buddy. Ive got a project in mind now everything's set up :)

It was worth doing :)

Thanks, it was going well till then end lol

lol, it does sound like you might be fighting a loosing battle there mate ;)

@@Granite-City-RC can I send you some snow!? Lol

@@HuckThis1971 errrrr.. i think you can keep it mate lol

it was a while back, ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-lwbGlazZeBU.html

there does seam to be some improvement, don't know if they would be better running on ESC's and not the stock motherboard?

@@Granite-City-RC For now I am running stock on drive motors. When mobo craps out I'll go esc's.

@@HuckThis1971 yeah i might try the same, but not overly fond of doing the electronics... mainly coz i have no idea what im doing lol

@@Granite-City-RC when I did my dump truck 1582/wpl b16 chassis I was confused. I couldn't power linear actuator off of a channel from receiver. It would only go one direction. I then came a cross a person who explained it. I now have 2 esc's. One runs on 7.4 volt for drive motor. The other 11.1 volts to drive linear actuator which is 12volts. Anything below 11.1 volts is slow and not strong enough. The trick is to remove the positive terminal from connector which goes into the receiver. So I removed the one from the linear actuator on 11.1 volts. I will make a video about that now that I think about it.

@@HuckThis1971 that would be cool to watch , and handy :)