Getting my long tube headers installed!!! 

I got 1& 7/8 , no cats and 3 inch all around. Now i have the magnaflow bullet

How long is the bullet? 6”?

Yes I believe so

4/7 I believe bro and thank you sir👍🏽

After the manifold

No

Kevin Thomas thank you sir💪🏽

Yes, its better to take it to a muffler shop

Speed engineering headers and 3’inch all the way out. Back then i believe i had a Carven R muffler

Custom y pipe

Corsa sport I believe

Has a magnaflow then went to a carven R then went to a magnaflow bullet

Yessir

Jason NNBS ahh nice I got a 2013 Silverado with a third car delete and muffler delete to bullet, but I’m really contemplating on headers I wanna be louder

You’ll immediately notice the difference once you slap them on bro

Ruben Salais thank you 💪🏽 and its in Pasadena on jackson next to a audio shop and they charged me 250 the guy knows me and i bring him people

@@jasonnnbs can I mention you if I take my truck there?

Yessir😼

Sleeper look 🤣

250 for a street tune bro. Depending on where You go get ready to spend around 700$

Can you use the super chips scanner for this vehicle to tune it?

You can buy i personally don’t trust em. Custom tune for me is the way to go

Yes, check engine light will come on

I had the carven but i switched to a magnaflow bullet

@@jasonnnbs which one is on rn? It sounds badd🔥

Kooks bullet muffler bro! Sounds good asf

My truck never went into limp Mode. It would just have a rough start then it’ll level itself out. Tuner deleted the check engine light.

@@jasonnnbs what does limp mode mean?

Truck not moving under its own power

It’s called evolution muffler

Speed engineering 1 and 7/8s long tube headers

Yessir🥶

Speed engineering. Had em for about 3/4 years now and absolutely no issues

Speed engineering 1 and 7/8s long tune headers.

Jason NNBS 👌

@@je820rry7 right now I'm running a magna flow bullet muffler. sounds way better then the obnoxious carven

Part out lol 50$

What year 2500 did you get hood off of

Corsa sport

Drew Hebert hood and grill i got it off a part out. Hood and grill are simple bolt ons

As of this moment. Headers , cai, built trans with a bigger stall (currently hurt lolz) built dif with 4.11s

What exhaust did u have on it before u installed the headers ??

Carven R muffler, as soon as i installed the headers it was wayyyy too loud

i doubt you’ll get sate reffed in a truck depending where you live, my single cab had long tube headers, fully straight piped, full tint all around even windshield was 5% and i didn’t get pulled over once🤷🏽‍♂️ but it’s all up to you, i’m about to get another pair soon for my 2012 crew cab

and i’m from the bay area

@@BenDover-vp9eg i stay in La took off the 3rd cat and sheesh

Yes you do

@@jasonnnbs thanks for the reply usually get no answer

No problem. Better get a tune as soon as you can bro. Its gonna run super rich

@@jasonnnbs for sure ready to see what it does

Its gonna waist hella gas depending what rear gears you have bro so I recommend looking into getting your dif built with gears aswell

Mark Tanteo its just dropped 3 inches front the back bro

How’s the ride after dropping the 3” in the back?

Rides pretty good tbh but im going to a 5/7 drop

Bypassed the sensors

Speed engineering

JORGE SALAZAR first muffler i got was a magnaflow then 1 year later i got a carven R and since then I’ve been rocking the carven. Debating on getting a magnaflow again but the bullet muffer

5 inch dual bro. Any muffler shop should have em

Carven R

Pacheco Kevin corsa sport

I had pacesetter

They should be fine bro

1 and 7/8s

My opinion is that people hype up the 5.3 so much that they forget that the 4.8s have balls too

@@jasonnnbs how about 6.2?

Farid Gadimov I’ve heard 6.2 with a full exhaust and they sound mean as well. Currently debating on a 6.0 or 6.2

@@jasonnnbs i have a 4.8 2012 1500 crew cab so far i put a K&N intake and outlaw exhaust idk if i should put headers or not 😂 has an aggressive sound to it but i want aggressive loud!

Get long tubes and slap on a Magnaflow bullet muffler

220$ bro

What brand headers ??

No sir

As open headers?

Ima put the headers on myself and go to the muffler shop and let them finish the rest

Yeah but its gonna be a custom Y pipe

Ima just run straight pipe no y pipe no none

Yeah that’s a no no lol. Youre gonna get annoyed

No problems

I had the carven R but i switched to a kooks bullet

Gerardo Escobedo headers tune intake. Same setup as me

And that was the problem lol

Jason NNBS if the cats on the ford where acting up the one thing bout the cats of there are clogged just floor it it it will blow it out

Speed engineerings website bro but i believe they’re on back order bro but you can check

Also was switching the gauge cluster plug and play? Or how did you do it?

Thank you sir🙏🏽 and yessir basically

The headers?

Just a 3 inch drop bro in the rear

Gonna change em this month. Dont drive the truck around as much anymore.

Its there wym lmao

What's wrong with the 4.8 ?

@@triggas80 almost v6 🤭

They handle boost better. Also rev higher in the top end. Youd be surprised what you could do with a 4.8 tbh.

I still gap 4.3s and 5.3s bubba😗

Love surprising people with this 4.8🥴

Speed engineering 🥱

Not gonna lie KHP is getting good at tuning but I’m not fully convinced yet

Jason NNBS they do good I got a tune by them

So how does this pass Inspection

Bryan Keels tuner deletes the code

@@jasonnnbs obd2 smog test pass? After tuning?