Hi Roger..... I should listen better, O replayed your video and you answered all my questions in the video. I just woke up about 3 minutes ago, I know that is no excuse but my stupidity sounds worse....LOL, by the way what stepper drivers are you using on your machine using the 5n controller
Hello Roger, After following how you did relief of the beautiful girl. I added and pasted. All looked good. When I got to creating a 3D tool toolpath, I was unable to select the relief. The doted rectangle and the circle around the relief were nowhere to be seen. I tried to create a toolpath, but it was machining the whole board. Is there a step I missed. Thanks
Hi Roger, are you using carveco maker, maker plus, or carveco full version. will this quality be the same in all versions or is it down graded in maker or maker plus
Hi, Carveco Maker will do this ok My CARVECO code 5% discount code is ROGERWEBB5798 (ONLY AT THIS ADDRESS BELOW) store-us.carveco.com/?ref=B40mt_z8N7xiu