PART 1- Full video is posted on our channel.
Products are listed at www.amazon.com...
The plug had a broken pin and the wires were brittle and chewed up.
So, I got a new wiring harness and everything else I needed.
First, I unbolted the wiring harness ground from the tongue of the trailer.
Next, I cut the wires and pulled out each section.
I bought this trailer new 23 years ago - and I’ve got a ton of use out of it.
This is the second time I’ve rewired it.
The LED taillights on this trailer were recently installed, but the front marker lights were old and corroded, so I replaced those as well.
All four of the screws broke off when I removed them. I used a hammer and punch to beat out 3 of the broken screws and the fourth one had to be drilled out.
The area around the marking lights was rusty so I decided to grind it down and repaint it.
I also hit the area where the wiring harness grounds to the trailer to make sure there would be a good connection.
After cleaning the bare metal with paint thinner I sprayed it with Rust-oleum’s paint and primer in one.
@hausplans
#tools #trailer #rewire #howto #diy #contractor #construction #building
25 авг 2024
