Any idea, why currently (April 2024), thingiverse offers a higher version (5.7.0) as the original Ultimaker website (5.6.0, even if 5.5.0 is printed on the side)?? I'm always a little bit confused?
When I try to download Cura(on both my Fire Tablet and iPhone), it only downloads a file full of what appears to be code. Any idea what the problem is, and why those grey boxes with the "next" buttons don't pop up, that would allow me to use the Cura software? Thanks!🙏
You can download it from our software page if you scroll down, the model shown is called the Wheel Pulley >> ultimaker.com/software/ultimaker-cura Good luck!
There is a script for layer height. SO you can begin a job with one colour and end in another but not to sure about changing materials. ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-h_Mohd7JLzw.html Hope it helps!
I can’t speak for Marlin. But with Duet RRF u can just put the GCode in the printer setup in cura and it works fine. I also run Klipper and this is done in the printer.cfg so it doesn’t really matter what slicer u use
How did you guys fuk up Cura so badly? I just printed a cylinder and when I sliced it and in the preview mode, there were all these white dots down the back, after printing.. IT LOOKS LIKE SHIT!!! looks like a big messy seam and I did the print at 100% no scaling, 50% infill I NEVER HAD THIS PROBLEM BEFORE!!!! WTF!!! 2 days 12 hours 28 mins WASTED! and one Spool of silk gold PLA 1.75 I AM NOT VERY HAPPY!! Ender 3 Pro, with BIGTREETECH SKR Mini E3 V3.0 32Bit Control Board for Ender 3, Ender3 Pro,
Cura is great! Except that you don’t have pressure advance for Uktimaker printers. U can get better print quality on an ender 3 then you can on S5. Not good enough - get it done.