Grado SR-60i single side detachable cable mod 

as the glue aged old, i couldn't put those 2 plastic pieces apart, i put the stuck part into a freezer and the glue went brittle, i was able to separate both halves

It's just stuff from radioshack - I since bought better connectors and wire for when I re-cable it, but haven't got around to that yet... and I cant find them to give you what brand they were.

so lucky!

link to what im talking about www.radioshack.com/collections/connectors-adapters/products/radioshack-1-8-stereo-panel-mount-audio-jack-2-pack

If you still want a Y-cable, you'd use two mono panel mount jacks; one for each side.

Inside each headphone, use some Colson-type hose clamps to block the wires.

@@woodoo4 cool thanks. wow I asked this 4 years ago.

No damage from the hair dryer. There's a bit air gap which provides insulation so it shouldnt be an issue - just dont point the dryer directly at an exposed driver.

I can't remember where I got those, but I've seen them in Home Depot, Lowes and Radioshack to name the more prolific of retailers. Here's a link to Amazon for an Irwin branded one www.amazon.com/gp/product/B000OQ21CA/ref=as_li_ss_tl?ie=UTF8&camp=1789&creative=390957&creativeASIN=B000OQ21CA&linkCode=as2&tag=n0841-20

It's probably called a reamer elsewhere, this is the item on DX www.dx.com/p/0-14mm-steel-hole-saw-installation-kit-41133#.WH_YiPkrJaQ

I kind of suspect they use cheap Y cables just to keep people coming back to them for repairs.

Scott Bakula On other hand, if my pair does not break for 2 years, I will take back my words. The cables do look really sturdy.

Scott Bakula Iv'e had my SR325i's for about 10-12 years of hard abuse. In an out of backpacks, to and from work, on trips, etc. I have never covered or protected them... just thrown in my sack and off to work/play/wherever. Not one issue since purchase. If you open them up you will also notice they use a simple cable tie (simple but perfectly effective) that keeps the cable from being "pulled" on at the physical connection. Short of intentionally yanking them out of the body, i doubt you will ever have cable problems with your grados. Also, the wires they use are exceptional and are heavy guage, well protected and durable. You can of course modify the headset if you really want detachable cables, but id rather not have another point for interference to present itself. These are audiophile headphones for careful listeners who want the most sound quality... not for enthusiasts who want convenience over sound quality. Every decision made is basically "will they sound better" all else may be sacrificed. Personally I like this about grados, YMMV.

***** Thank for that extra bit of reassurance! That means my model will serve me well.

***** My comment probably sounded more cynical than intended. I agree, more or less. I've actually owned a set of SR-80s for the last couple years. My very reason for watching the vid was to get an idea of how to repair a worn out cable. The short doesn't often occur at the ears, so you're probably right about the cable tie. It occurs where the cable 'rocks against' the plastic Y joint. The wires become can eventually become frayed purely out of frequent use. So that considered, a DIY single-side mod is a pretty good solution, as opposed to paying Grado labs to replace it with the same Y-cable. I definitely don't doubt your experiences with them, but this has apparently been an issue for others. They are definitely some of the best sounding cans I've encountered though and hands down the best in the price range.