Hands on Tool Test of the Bora Router Dado Jig 

So, you did mention that one must hold the router down ("gravity"). But when you first start the cut coming from the edge of the board, this plastic plate is very wobbly with a heavy router perched on it. The first time I tried it, the router bucked sideways, and there went $45 in orange chips. The hole wouldn't fit the guide anymore. After sleeping on this problem and mumbling bad words about Bora, I came up with a solution that does work. I traced out a 3/8 piece of plywood, attached it to the base with Super 77 spray glue, and bored a new 1" hole in that "sandwich." Then I found a spot on my router where I could bring a 1/4 bolt up through the base and used a wing nut to affix the router to the whole thing. The "new" base doesn't interfere with the thickness adjustment of the Bora jig. So, if you want to secure your router to this base, you might try this work-around.

It works pretty good but I don't have a router table or dado stack to compare it with and because of the additional collar and the orange base I have had to choke up on the router bit in the router unit to give it enough length to do > 1/4". Thanks for the review!

Thanks for the review, man!

I noticed you had a Milwaukee router but you chose the Makita. Does the Bora work with it the Milwaukee?

This guys shop looks like the Home Depot tool wall. I would say Lowes but they don't carry TriTech or Makita.

Where did you get the sub plate?

Hello sir thanks for the video i had a question, what kind of router i use it for that is it palm or plunge router?

Sir i will complete my question what kind of router bit i use if ill make a groove an t-slot track saw table chut.. sorry because im a beginner sir

Does this work with the m18 router as well?