Harmonics in electrical installations: what are they, how are they measured and analyzed? 

3:17 Not exactly true. The definition of a linear device/load/component/element/network is not that which draws sinusoidal current when excited by a sinusoidal voltage. The definition is if it satisfies the superposition principle. There are linear loads that draw non-sinusoidal current when excited by a sinusoidal voltage. Example: linear time-variant loads. For some reason in Power Engineering, they say linear loads are those that draw sinusoidal current. But the definition of "linear" based on superposition is consistent with the definition used in Signals & Systems, in Differential Equations for linear ODEs, and in Linear Algebra for linear transformations. So it is clear the definition used in Power Engineering is the one which seems wrong, since it is inconsistent with many other branches of science. If you want to refer to a load that draws sinusoidal current when excited by a sinusoidal voltage, that load is linear time-invariant (LTI). If you want to refer to a load that draws non-sinusoidal current when excited by a sinusoidal voltage, that load is non-LTI (either because it is non-linear and/or because it is time-variant). 4:05 Note: Fourier did not invent the FFT algorithm. 4:57 In a cycloconverter, the fundamental cyclic frequency of the current is not 50 nor 60 Hz. 6:42 Actually, the frequency spectrum consists of two graphs. The one shown in the video was the amplitude spectrum (normalized). The missing graph is the phase spectrum.

item 1,2,3,4,7,10,11 rather this is the correct control tolerance specification or not ? I am not sure it that any tolerance control tolerance specification for item 5,6,8,9 ? Parameter Calculation method Specification 1)THC(A)

Hello sir, Thankyou so much for this wonderful video, I would like to know that as at 10:40 you mentioned that THD for current distortion does not give clear vision in comparison with TDD, can you please explain me more, as i m doing a project and in my project tdd is under limit but thdi is 48 percent, will it be acceptable according to ieee standards?

Double like!

Is connecting line to line prevents zero sequence by not using grounded current carrying conductors

this was a very helpful video, will be coming here again as the some parts were a bit difficult to understand, appreciate all the efforts you took in making this video. thanks a lot

Why does that man have a face tatoo

Very good explanation, even for people who are not familiar with the topic

Hello, I just want to ask, what is order in harmonics? And why every time the order comes up, the multiplier of the frequency goes up according to what order they're in?

Sir. Can u give excample to reduce harmonic 5th in Vidio using passive filter.

Sir can you make a vedio on Asymmmetric cascaded h bridge multilevel inverter with comparison of thd in the basis of low thd and high thd

Thank you for wonderful Technical session

Great video information 👍❤ thank you for sharing your knowledge ♥️🇵🇭

Great video .....

Thanks

Nice ❤

Very good demonstration

nice

really helpful

Thank you for creating the best explanation.

Great video bro

Thanks for this.

Cool

excellent work