So, at this point, we know I had the plug back wards (reverse polarity). Since I couldn't find any videos on here about this setup, we'll use this as an educational video. Go check out the video that shows it working, and this might help some of you out there.
You plugged the battery wire in the wrong way unplug it and flip it around. I did the same thing it took me forever to figure it out. I did the same thing!!!
Hey Man if all else fails just refer to the manuals !!! Also don't bind the receiver to the radio with servos plugged into the receiver one you see the green light on the receiver turn off your transmitter and unplug the batter from the rx then power th rx and tx back on the light on the rx should light up green !!! Hope this helps!!! Cheers carl 👍
Hey bro, try turning your controller off again and battery off and then turn all back on again Oh, make sure you’ve picked the right setting for telementary receiver Is your battery a Lipo battery battery?
Take out the battery plug on the SB on your receiver and put it in slot number four at the top, then put your tworeceivers in one and two not Cbus ones