This tutorial used to be an exclusive tutorial, now being released to the public. Here is the link to part B • Holly and Berries Set ...
Supply list and added instruction below:
This item is available for purchase in this Facebook Group. You must joint the group in order to see the items. / cherylstpierreofmajest...
Want to share a photo of your Work? You now can at my Facebook page meant for sharing. / cheryl-st-pierre-of-ma...
Bend wire at 4 inches/10 cm. for holly leaf and bail.
Measure and mark wire with fine point permanent marker at 10mm and 13mm for holly leaves.
bend wire at 2 inches (5cm) for first berries.
Spray lacquer - I recommend spray lacquer that is meant for metal and toys NON TOXIC. I also recommend that you do not put this on the ear wires.
The reason I recommend using lacquer on this set is that it is seasonal jewelry and copper jewelry that hasnt been worn in a long while tends to discolor a lot. I normally do not put lacquer on my pieces.
Supply List:
6 - 7 inch (17.5cm) pieces of 20 gauge (0.81mm) soft copper wire for the holly leaves and the berries.
1-9 inch (22.5cm) piece of 20 gauge (0.81mm) soft copper wire for the bail.
1 - 40 inch(100cm) piece of 26 gauge (0.4mm) soft copper wire for your coiling wire.
9 - 2mm(approximately) green seed beads that fit on a 20 gauge wire. For the holly leaves.
9 - 3-4 mm red jade or glass round beads to make the berries.
chain nose pliers
flush cutters
Ruler that has metric measurements of cm and mm
fine tipped permanent marker
Optional - Spray lacquer meant for metal and toys, NON TOXIC.
26 сен 2019