Honda Rubicon 520 & Warn VRX Winch Install 

Reading the directions helped me alot when I stalling the winch on my son's 250 recon. The blue, yellow wires were too short and the red, black wires from warn were wayyyyy to long so I swapped them.

The solenoid goes under the gas tank, using a ubolt type of mount to one of the frame tubes going down

You know there is a sub harness for the hand grips and winch on that model yeah?

What is the brand and part # for the winch mount you used?

How did you splice the 12v connection? Did you use a sub harness

Can you link the winch mount and the winch from Fortnine website ?

Did you have to trim the plastic at all for the winch to fit. Others have mentioned that trimming is required with the kfi mount. Just curious.

Did the winch come with the switch and everything needed? Besides the mounting plate.

I must have missed how you mounted the solenoid. Zip ties?

How many pound winches is that? is that enough if this vehicle gets buried

I cannot believe you drilled the frame. 😖

Holy shit you just voided your warranty by drilling through the frame. 3-4" from the hot exhaust..?? Yikes. Good luck

Bad move on the holes in the frame. Storage area would have been better