Hi, thanks for the video. I have a problem with water intrusion with this model. Water appears even on flat days so it's not coming in over the tubes or transom. When accelerating and the bow of the boat starts to lift, all the water suddenly appears at the back of the boat. There are no signs of any damage, the boat is brand new. I had the same problem with the T38 and my dealer took the boat back under guarantee and marking the boat as "faulty". Now it's happening again with the T35 alu and the dealer doesn't believe that there can be the same problem again on a brand new boat so I'm stuck. Any advice? Thanks
Not sure I can help much on this. You will always have a bit of water in the boat that will indeed go to the back when you accelerate. I assume you are putting the bung in the boat the correct way ie from the rear
It gets much easier after a couple of times, you get better and the boat stretches a little. Getting the rear floor central is critical. I have a t40 and install the floor with hardly any air in at all.About 20 mins for full setup
That is very quick. We tried with very little air but found the tubes just kept flopping forwards and made it even harder to get the floor in. I was thinking of a T40 for the trailer but went for the T35 as it is quite a bit lighter if me and her indoors ever have to lift it
Putting the floor in really isn't difficult. You have put far to much air in tubes before fitting floor. Half full at most. Tubes should barely hold shape and still be a bit floppy.