@@tractorsmarinemechanic I can't say for certain, but this may be the 100% exact match (Equivalent) to 724070-51700 (Yanmar Injection Pump) on my 2qm15 engine
Hi I rebuilt mine too get some parts unstuck and now the tractor runs good but it leaks around the fittings at the top. Seems maybe the o ring is too rotted. Do you know what torque to tighten the top fittings or where to get a new oring? Thanks
Hi. I put the plunger back. I have been told that the plunger might be the reason why the pump doesn't inject . It has to be out back the correct way. Do you have a video that shows how to do it?
I Have a situation, my skid steer didn't turn on. The pump is very similar. Some suggestions!! THE diesel pressure is correct at the side of pump, but no pressure out of the pump. Any suggestions please
New subscriber sir..pinapanood q mga vids mo sir.gling mo mekaniko.. Ung father q sir may luma na L1801,ask q lng qng marami p b mbbli na spare parts nia..?
The thing for me is can the internals be changed around somehow to give full fuel to the left instead of the right on the moving rack. The governor on an MWM similar engine when started seems to snap to full throttle with the incorrect Bosch pump I located.
Do it man.your plunger maybe stuck up because of water inside your pump.you can fix it by metal polish.watch another video that I'm using with metal polish.clean your fuel tank and replace fuel filter.
Thank you.you can repair your own injection pump i knew you can do it by your ownself.do not send to the calibration center.they cannot calibrate that.the only they can do is to repair or replace plunger.thank you.
@@tractorsmarinemechanic iseki 2cyl Mitsubishi KE75 I subscribed and re cleaned injection pump using your videos...im getting fuel but need to check the timing I have no shims to adjust or don't know how?
@@lgvmobile same boat here, KE95. I thought there was supposed to be a big shim under the pump, but all I had was a gasket. Did you ever figure out how to set / check your timing?
@@tractorsmarinemechanic Thank you! We are taking about under the pump mounting flange? Where the pump mounts to the engine with 4 bolts? We are supposed to remove the old fiber gasket and install shims where there were no shims before?