HOW TO: Bleed Your Tony Kart Brakes The Easy Way - POWER REPUBLIC 

very good channel to learn the basics on the kart! 👍🏻👍🏻

I’m getting air in one side of my caliper each time I bleed. Brand new seal as well. Bleed nipple isn’t too damaged, brake line and fitment are both snug and secure and I only rebuilt the master cylinder 3ish sessions ago. I’m using DOT 5 fluid with an SA-2 caliper.

Guess what am doing tomorrow. Thanks for showing this. I enjoy ur channel heaps

That's a great video I love the bottle idea

If I’m not mistaken, you don’t need to pump the brakes when using the otk brake bleeder. The point of it being so tall is that the tool presses the fluid into the lines once the bleeder nipple on the brake caliper is cracked open. This makes the process much simpler. Please correct me if I’m wrong.

water can be be compressed?? anyways, love the channel!!

love u guys!

Thanks for the video 😊

Thanks for this ive been doing it wrong for years🤣

I’m sorry kinda confused. Is using the hot sauce bottle a 2nd method to bleeding brakes? Like will it remove the spongy feel? And how long should I leave the brake nipple loose when it has a line attached to it.

Nice vid 👍👍👍

Love the content guys 😎

0:05 The good old flying goose sriracha!

Hey Des, how close should new pads be to the disk? I just put new pads in and the disk is rubbing when I turn the axle. I've moved it over in both directions and I can't get it to spin without touching. Kart is a 401R

Do i need Tony kart brake bleeding tool or i can go with a standard method with pushing brake pedal?

Hi power republic, when my brakes aren’t on its lop sided but when it’s on it pulls straight and perfect, is that still fine ?

What is the best way to bleed/ fill brakes with a 90's BSM brake calliper without a bleed nipple? I tried doing some gravity tricks but doesnt seem to get all the air out.

One thing which i would like to fully understand is on the hydralic hand brake (used on front brakes or with rear brakes for disabled drivers ect). What is the recommended method to bleed that front handbrake system? Fyi, i tied the steering off with the resavoir and pipe pointing upwards. Then used a small coke bottle taped ontop of the resavoir with brakefluid in to increase fluid volume. Then opened bleed valves and pumped, closing before air backed in and the lever released again. I did each nipple a few times ect until they worked. The hard part is dismantling the bottle without dousing the kart in brake fluid... how exactly is that avoided or is it normal?

I tried the sauce bottle method. It filled up the reservoirs but there was no brake fluid coming out from the bleeder nipples. What could be wrong?

What if there’s no nipple bleeder on my caliper ?

Hello, can I use DOT 5?

My bleeding screw broke and stuck inside the socket, is there any other way to bleed the brake system without using this valve? i have a pcr chassis.

Come on all of you they gay is doing a free video at least appreciate, That’s clever make sure to wear clove’s and wash with water when you finish,Some people might not have the money to buy the genuine bottle ,

very confusing