HOW TO CLEAN, LUBRICATE, AND ADJUST THE BLUESTREAK 629 FABRIC CUTTING MACHINE 

thank po sir, keep watching

Glad you like them!

Thanks for watching po

You are so welcome

Stay connected

Thank you too

Thanks for watching!

Thanks a million

Thanks for watching

So nice of you

Glad it was helpful!

same to you po, thanks for watching

Thanks for watching!

salamat po sa pag watch.

Thanks for visiting

Glad it was helpful!

Thanks for visiting

My pleasure 😊

Thank you too

Thanks, you too!

Thank you too

you are so welcome, thank you for watching.

Thank you, I will

Thanks so much

Pls make sure that the lock washer is there with the set screw. Check also the thread of the set screw if it is still okay or need to change with new screw. Thank you sir.

More to come!

The knife should be at center of the sharpening belt. Do it by turning sharpener centering adjusting screw. You tighten or loosen the belt by setting its pressure spring. Thank you for watching.

check the capacitor for single phase motor, check motor shaft bearing for lubrication, check moving parts for alignment. thank you

Hello there, I am a Filipino. Thanks for watching

Yes maam, may video na po tayo dyan sa channel ntin, isearch nyo lng po ang pamagat niya ay, "how to change sharpening belts of bluestreak machine, salamat po maam,

That is the driver pulley. It drives the sharpener to go up and down, thank you for watching sir.

Mga maaring problema, una baka baligtad ang rotation ng motor. Pangalawa, baka pudpud na ang gears na nagpapaikot ng square shaft. Pangatlo, baka yung rubber wheel ay di na kumakapit ng ayos sa balance wheel. Thanks po for viewing.

check nyo po ang oil felt baka sira. dapat pag lagay mo ng oil sa reservoir dadaloy unti unti sa felt papunta sa blade pag umaandar na ang machine. pagnakahinto hindi dapat umaagos sa blade. yunt felt ay parang basahan na dinadaanan ng oil papunta sa blade. ang langis dapat yung pang eastman cutting machine din ang gamitin mo. wag yung pang sewing machine kasi malabnaw yun.

Yung po ganyan model ay walang centifugal switch, kung yung sa inyo cutting machine ay meron, available po sa lazada ang mga centifugal switch, sure nyo lng ma order nyo yung exactong kagaya ng sa inyo. Salamat po sir.

Malamang sir may leak ang windings nyan. Ibig ko sabihin may nasugatan na wires tapos dumikit sa body ng machine. Delikado Yan sir, I hat kayo. I check mo Yung wirings gamut ang tester Para Malamang mo Kung Alin may sugat. Lagyan mo ng tape. Siguruhin mo na nakakabit din ang ground wire. Ang ground wire ay kulay green or yellow green. Salamat po.

@@VaLentinOGanadoreS slmt po sir checko Uli.

Sana o sir mapansin nyo message ko salamat po

Opo sir remante, pano po bang ayaw? Di po gumagalaw o di po tumatalab sa tela? Umaandar po ba ang motor? Mapurol po ba ang blade? Paki linaw po sir, matulungan kita sa problem mo, salamat po

Ang cause po ng paginit ng machine ay pag hirap sya sa pagikot. Makapal at matigas ba ang tinatabas o wala sa align yung slider ng connecting rod? Pede rin kulang sa lubrication kaya mabilis uminit ang machine. Yan sir ang possible factors.

Marami pong dahilan, isa po ay hindi smooth ang ikot nya. Dahilan po ay poor lubrication o misalignment ng mga parts.