In Today's video I will show you how to hookup 2 alarm powered sensor to 1 alarm wire. This will work on any alarm system. Please don't forget to Subscribe, Thank you! VPN Special Surfshark: get.surfshark....
Confused why he tied loop common to ground? Totally unnecessary. Just tie yellow from motion to common, otherwise this would cause a ground fault on a Bosch panel.
Brilliant! I'm having a new panel fitted tomorrow (self install). old one being removed by a company. I have 2 exterior sensors with 1 cable going to both in series. Think they used the atz function due to not having enough zones. Not 100% sure. I have more zones now. So this is how I would wire up 2 takex MS series in the same way? Where would I put the eol resistors here? Thank you
Hi Jason. I have 4 IR beams ( 2 receivers & 2 transmitters) that i need to connect on 1 zone. How do i do that, cause when i connect the 2 NC & 2 Common to the one fron the panel, it doesnt work.
You can't do that, you have to connect it in series. See this photo. cdn.getawaycouple.com/wp-content/uploads/2022/01/31093839/Series-VS-Parallel-1024x576.jpeg
Thanks for the video. Is it possible to program the pgm arm/disarm function to also have a panic if it is held. I.e. 3rd party remote button press arm/disarm and remote button hold to trigger panic
Great video. I would like to take a place where I previously had a window with a window contact and reuse the wire for a glass sensor. The problem is the glass sensor needs 4 wires and the window contact only had 2 wires. Can I jump the 2 to create 4?
That's right, it won't work. But check your alarm panel, it's got to be a 4 wire. I think you have this type of contact. m.media-amazon.com/images/I/51YAsF8vb4L._AC_SL1000_.jpg