How To Delete/Remove The DOD (displacement on demand) On Your LS Engine (5.3-6.0-6.2 liter)

Подписаться 13 тыс.

Просмотров 52 тыс.

50% 1

This video shows you how to change the parts in your engine to delete DOD, DOD is what the vehicle uses to be more fuel-efficient, also known as Active Fuel Management, it is also notorious for failing and causing some serious engine problems. This video will show you how to remove the DOD. After doing this I recommend getting a tune for your vehicle immediately. You will need to get online and look up "DOD delete kit" for your specific engine. That should include all of the parts we use in this video. Thanks for watching! If you liked this video be sure to subscribe for more!

Опубликовано:

2 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 104

@kelseylucido3166 Год назад

I guess you didn't see that chunk of glass under the drivers side rear lifter cradle.

@stevenlynch9947 Год назад

Did you change the cam? I see some videos where it said you have to change the AFM cam.

@aprilgeneric8027 6 месяцев назад

did you listen to the video....he already stated use the whole kit replace everything...CAM is one of the parts

@akakumacrash3376 Год назад

u mean to tell me he trusts o rings more than plugs that are drilled and tapped 😅

@aprilgeneric8027 6 месяцев назад

he doesn't trust YOU and every other knucklehead operating power equipment to not misuse or make a mistake with the teflon tape...guess your hearing and comprehension justifies his statement.

@kkakis Год назад

I came here for the piece of glass, Yeah It worked! LOL 😆

@1018Video Год назад

Horsepower.

@SpynCycle57 2 года назад

The more of these videos I see, the happier I am with my 2004 Avalanche. No DOD to deal with.

@1018Video 2 года назад

Yeah I hear that!

@Lowgxp Год назад

I’ve seen videos of tunes like the Diablosport allowing you to disable the dod from kicking in without removing any of this.

@1018Video Год назад

The problem with that is that the lifters that are notorious for failing, and are the main reason for people deleting the DOD on these engines, are still in the engine if you just get a tune that turns it off.

@daviddubuisson5194 11 месяцев назад

The failure happens from a miss timed evend causing the pin to get lodged and cause the lifter to stick disabled if the lifter never goes into disable it can't get stuck

@aprilgeneric8027 6 месяцев назад

@@daviddubuisson5194 the failure happens when the spring between the two pins gets worn, and the pins don't retract properly...a miss timed event happens once every 2000 events or so any ways and with enough of those the pin(s) get bent into the opening and once that happens...just a matter of wear and tear until it becomes catastrophic

@russellsiroisjr2334 Год назад

Shade tree mechanic's, remove the head starting it one end, has no clue. Remove same as installed.

@ferdburful6352 9 месяцев назад

Great video on how NOT to perform this mod .

@1018Video 7 месяцев назад

It worked lol.

@tsigoloiborcim 3 года назад

Did you leave that chunk of glass in there with the lifters? LOL

@1018Video 3 года назад

Yes, added about 20hp.

@dannycreech4177 2 года назад

Lmfao!!! 🤣😆🤣😆 9:39 it's to big to get sucked up through the pickup screen on the oil pump!

@mikel5571 9 месяцев назад

Hmmm. Probably not how clean I’ll keep mine. But it might work.

@1018Video 4 месяца назад

It worked but there are better ways lol.

@chadbailey189 Год назад

just yout opinion, do majoritie of lifters not fail and majority of 6.2!? i see alot of ppl say they have no problems with 250k miles plus also to avoid lifter problems change oil a 3k mile not 8. 9 ,10k miles?

@1018Video 11 месяцев назад

All GM V8's (even the newer ones) with DOD have a high probability of failing.

@Johnny-jr2lq 2 месяца назад

Oh my goodness that wasn’t glass that was metal. bearing material ????? Yeah if that motor is still on the road I’m definitely not worried about doing this on my 2012 LC9.

@1018Video 2 месяца назад

@@Johnny-jr2lq Still runs fine today. 😎

@Johnny-jr2lq 2 месяца назад

@@1018Video not joking that is amazing

@1018Video 2 месяца назад

@@Johnny-jr2lq Engines are stronger than most people think.

@kinggfears 7 месяцев назад

Man you got to be joking this guy doesn’t even clean the block all that debris and glass

@1018Video 7 месяцев назад

Yeah that's fine.

@junioravj9050 Год назад

great video

@santanabori Год назад

did you had to change the cam?

@williamcunningham1448 Год назад

The stock cam will not work with those lifters. You MUST change the cam.

@1018Video Год назад

How is that? What is the difference in the cams?

@kkoch666 11 месяцев назад

Lift, duration...

@nhabibhabib2135 2 года назад

Those lifter maybe junk or not but the one you going to put is after market they worst then a junk they are not any special

@1018Video 2 года назад

The special thing about the aftermarket ones is that they are brand new and the ones we took out of the motor are old as hell lol.

@frankrenteria4370 3 года назад

Dont you have to lube the lifters?

@1018Video 3 года назад

If it's in the video, yes, if not, no, lol.

@xpro808 3 месяца назад

Don't you have to change the camshaft too?

@1018Video 3 месяца назад

You do not.

@RubenGarcia-or1id 2 года назад

Jesus break everything by hand first then run them out with the impact

@1018Video 2 года назад

Nahh, lol.

@scotty_miller92 6 месяцев назад

Only way to not have to get a tune is keep the old valley cover and keep it plugged up, keep it at the back/side of the motor somehow and drive in M5 Mode it willl never kick v4 mode on. (Alil temp hack) Mine still has dod (which i hate) and i drive in M5 mode and it stays in v8 mode

@1018Video 4 месяца назад

What is M5 mode?

@rustystubbs242 3 года назад

Good video. I would have had that engine cleaned up before putting those lifters in. When I worked in a few auto dealerships way back when, two things were guaranteed to get you fired if seen by the shop foreman…1: using a crescent wrench and 2: using a impact to put something back together.

@1018Video 3 года назад

This is a weak impact, couldn't break a screw on a toy, lol. Yeah it was a dirty engine but they didn't pay to have it cleaned, cleaning takes quite a bit of time to do it right.

@jerrya2801 2 года назад

@@1018Video Are you kidding me, there was a chunk of glass in between the new lifters that you left in there, what a JOKE!

@midwestcatz5896 Год назад

@@jerrya2801 lmao ! @9:30

@darkmatter7399 8 месяцев назад

Back in your day people got fired

@cammims7645 2 года назад

Sweet! Can't wait to do this to my 2007 Impala SS. But imma do it with the motor in the car.! Thx for the Video!

@1018Video 2 года назад

May be a little difficult on that car with the motor in it, those have sideways motors cause they're front-wheel-drive, some things may be a little hard to get to.

@cammims7645 2 года назад

@@1018Video I'm aware. Now do I absolutely need a tune after? What does a Tune do?

@aprilgeneric8027 6 месяцев назад

@@cammims7645 computer is programmed to use AFM, so it's going to try and activate the AFM system...with no system the computer is going to get no response and tell the auto " hey something is broken, reduce power and speed to 15mph turn on the service light refuse to start until gm fixes what's wrong"

@Edgrrrrrr Год назад

What kinda of motor is this? I have an L99 Camaro 2014 6.2 are they all the same way to delete DOD or slightly different? Thanks either way!

@1018Video Год назад

I believe it's the same for them all.

@Lowzaracing Год назад

sloppy mechanic

@1018Video Год назад

It works lol.

@miguelramos7352 6 месяцев назад

Had a question, when I do my DOD Delete on my 2008 GMC Sierra, is it necessary to change the Camshaft? Also where can I get a DOD Delet kit? Thanks.

@aaronzavala4336 5 месяцев назад

Did u find out that’s what I’m tryna figure out

@1018Video 4 месяца назад

You don't have to change the camshaft.

@robertevans9354 9 месяцев назад

My late model kit runs 1200 bucks from ams racing ,

@1018Video 9 месяцев назад

Not a bad deal!

@davidcruz1602 2 месяца назад

Se reutiliza el árbol 🌲?

@1018Video Месяц назад

I'm not sure what you said.

@albertocaldera2819 2 года назад

Buenas tardes hice ese trabajo pero me fallan los taquetes cortos dónde reemplace los integrantes... No sé que problema tendré ahí, deje la misma leva no sé que más podría hacerle para quitar la falla... Saludos

@1018Video 2 года назад

I don't know what you said.

@robertevans9354 9 месяцев назад

You put the old cam back in , or you left it in

@JG0923 2 года назад

So i bought a cam kit for my 2011Camaro ss its an Automatic . I bought the kit from tsp it comes with the basics but it didn’t come with a dod/Afm delete kit . If i want to cam my camaro i have to get this kit correct ?

@1018Video 2 года назад

You'll need to EMail them and ask them, that's pretty important.

@1SageP1 9 месяцев назад

What a monster this guy just used ugga duggas as torque specs

@1018Video 8 месяцев назад

🤣 🤣 🤣

@luiscardozo0000 10 месяцев назад

oh my god this pseudomechanic ...poor customers

@1018Video 10 месяцев назад

It worked out quite well.

@lenny_miller2357 2 года назад

Can I just do a AFM DELETE without changing the DOD lifters?

@joshnmn6794 Год назад

It's the same thing

@delwortman2799 Год назад

why did you not change the cam

@1018Video Год назад

It had no damage.

@papergatorzfedducca7998 Год назад

New subscriber 🔥🔥🔥

@1018Video Год назад

Thank you! I appreciate it! Thanks for watching!

@everherrera2393 2 года назад

Saludos Usted cambia el árbol de levas? Le realiza algún cambio en software de la computadora del carro?

@1018Video 2 года назад

Not sure what you said.

@macbacb7006 Год назад

You change the camshaft and do some tuning to the ECU?

@318ryder2 2 года назад

Man what oil pressure filter did you used

@1018Video 2 года назад

I don't remember lol.

@Nadaaa4 Год назад

@@1018Videowhat’s a good site to get the dod kit from. I see several of them but I want the best or durable stuff

@raulreveles6293 2 года назад

What happens to the knock sensors?

@1018Video 2 года назад

I don't remember, I'm the camera-man, if it's not in the video I wouldn't know lol.

@Claybaby1992 10 месяцев назад

Knock sensors on this generation 5.3 are on the sides of the block.

@rlnhrd276able 2 года назад

You're rough af bro

@1018Video 2 года назад

It works lol.

@rlnhrd276able 2 года назад

@@1018Video yup that's the best part.

@patrickreynolds8337 3 года назад

Did you change the cam?

@1018Video 3 года назад

Yes, but you don't have to.

@delwortman2799 Год назад

@@1018Video yes you do

@1018Video Год назад

@@delwortman2799 Not necessarily, the cam is no different from any other cam, there was no issue with this cam but the owner had a bigger cam for us to install. The most important thing to do when doing the DOD delete is to remove the DOD lifters and install normal lifters, that's what fails on these engines, the lifters.

@kevinhumphrey932 2 года назад

Can you still run dod camshaft I was told the lobe height and lobe off set was different there for you had to swap out the camshaft for a non dod camshaft

@1018Video 2 года назад

I don't think you have to change cams, I've got a friend with a 2020 Camaro SS and he did the DOD delete and he still has the stock cam.

@matthew6202 Год назад

Yes you do have to change the cam don’t listen to this guy. Don’t do all this work for nothing.

@delwortman2799 Год назад

@@1018Video you have to change the cam

@1018Video Год назад

@@matthew6202 The cam is literally no different from any other cam lol the lifters are what do the DOD, you only have to change the cam if it has damage.