How To Drop A Datsun 720 Pickup Truck 

U-bolt nuts are torqued to 58ft-lbs if you think you had trouble getting it even. I also use a digital caliper to measure the threads on the bolt when cranking the torsion bars up/down to get the ride height even.

Clean truck .🔥

One of the nicest videos I seen today

Chelu i enjoyed your video. Although knowing how to do it i like to watch anything mechanic. With the yoris!!! Heck yeah brotha

love the video, My 80 Datsun 720 king cab height is like a 1" or 2" lower on the driver side than the pass side. Is all i do is tighten up the driver side to bring it up some, or do I have to pull the bar off and move the spine a notch over a turn on driver side to go up a little? I want to bring up the driver side to match the passenger side height

Chrome sockets on an impact. He knows what hes doing

You did okay it was kind of amusing for me I would have taken the tires off in the back so you're not laying underneath it never use a crescent wrench and I thought you were going to lower this truck you can take that extra block out take those extra leaf out just use the one main big one and your helper small spring that will get you your drop and as for the front you did it right except for you don't need to take it for a test drive just push up and down on the fenders on each side and see where it sits and if it's not where you want it readjust it the same way you were coming down or if it's too low go back up but you have to count each one of those bolt threads on both sides so they match I usually measure each side 1 in but you don't have to do that some trucks sit one and a half inch but it was a good how to video I like that yellow banana except it still sits way too high 😂😂 keep up the great videos I subscribed to you because I want to see what you do with your channel good luck buddy don't give up just keep plugging the videos out

Where do you buy those blocks?

You could have removed another leaf. These stock motors won’t move that rear end much.

Not wild about lowering these nice little trucks like that, nor puttin wagon wheels and thin tires on them either.

Yo we’re you been clean truck it’s vance

How did you calculate how much the torsion bar needed to be lowered in order to fit the correct ride heigjt

Never stack blocks like this not safe on a big bump just saying 😎

👉👍👍👍👊👊👊✌✌