This is the most common method I use to finish vinyl siding at the top of a flat wall with an eave overhang (including installing the top piece of siding, F-Channel, vented soffit, double metal J-Channel miter, and finally aluminum fascia metal). In this method I utilize a slot punch tool in lieu of undersill to better hold the piece and to save the customer money by not having to purchase as much undersill trim.
Note: If the soffit and metal is already done or there isn’t enough room for the top piece of siding, I employ an alternative method where I use undersill at the top, because you’re unable to get the siding behind the F-Channel at that point. In short this is a soffit and fascia installation guide.
------- Contents of video--------
00:00 - Measuring and cutting top rip
01:23 - Using slot punch
03:25 - Making a hole for a wire
03:53 - Installing the top piece
05:46 - Installing F-Channel
12:44 - Measuring and installing vented soffit, including miter
24:06 - Measuring, cutting and installing fascia metal "The End"
15 авг 2024