How to fix “Check Vehicle Stability Control System” with Check Engine Light error on Toyota Vehicles 

Thank you! I got the same message after an oil change and became very concerned. After watching your video, my husband checked under the hood and saw that the hose you were talking about was left disconnected after the oil change. He reconnected it and that took care of the problem! Thanks so much!

I just got this error message yesterday. In checking what you suggested, I found that when I changed the air filter a few days ago, a rubber hose came off. I put it back on, checked the gas cap, and still had the error message. I then disconnected the battery, waited one minute and reconnected it. And presto the error message went away and my cruise control works again. So you just saved me about $200-300 I would have spent at the local auto repair. Great step by step instructions and fix! I have a 2015 Toyota Camry XLE. Thanks for the tip!!!

It's worked for me, Camry 2016

TY… simple and straight forward. Saved me $150

Thanks a bunch. Had a oil change and the guys when they checked filter knocked the hose loose.

Just had the exact same thing happen after an oil change. Thank you. Great step by step fix!

The tool is a wrench - you can also use the round end to loosen the nut. I just got that same message on my 2017 Camry. I will try what you suggest and report my findings. I enjoyed the video 😃

Thank you! You helped me fix this error on my friend's car

The car may have a button next to your left knee which you can push to turn off the message. The button shows a car with a wavy line underneath it. Just press it and the message will go off. But as said above, it does not fix the problem, it only turns off the message. If there is an actual problem, the message will reappear.

Great sir. I fixed the same problem. May Allah bless you ✨️ 🙏 always.

Thank for your informations. At my toyota I fixed the problem ! Thanks again.

Thank you. It did work on mine 2017 camry

That's actually not fixing the issue, what it is it's erasing the code, temporarily. If the problem persists, it will actually come back on within 50 miles. All you're doing is erasing the temporary data that is showing on your dash.

Great video thanks!

It works thank you so much

If you do that the mesage will come back after you drive off for se time. It takes one full drive cycle. And the tool used for the battery is a 10mm wrench. You can also use pliers if you do not have the wrench.

Thnx so much u are so awesome 👍

Thank you boss😅

Thank you sir

thank you it’s work

Thank you

Really great video.

Mine just did that for the first time I was in shock cause I didn’t know what to do I dnt even want to drive the car for a long way I thought it was big problem or it might have to stop with me in the middle of the road 😊 And abt if the light still flashing on the dash it need to check as as possible pls ???

I have this problem along with check engine light

Excellent video

Did it come on back later on after driving?

Thanks a lot it worked

I have 2007 camry hybrid. My brake likes,traction stability vsc and abs on. Can you give me any advice? Thank you

That only resets the lights on dash it does not fix the underlying problem if suspension issues

I disconnected the battery also on a 2006 Toyota sienna van and the light went off for a couple of days and it went back on again

So what was the problem 🤔

And the light open again and again

😂😂😂😂😂😂😂😂😂😂😂

The car will lose traction and stability eventually. Steering wheel was erratic. Vehicle stability messages started displaying. I tried to get an alignment done, that didn't fix it either. Solution: I replaced the battery and the problem was solved.