+Josh Eichelberger Actually most cases are due to line loosen. The worst case is control board no working, but replacing is not complicated either. You can see my other video- how to take part the scooter.
Hi I just got the board the other day and when I try to ride it wheels do not move the circle light on the left side don't come on when I stand on it also just the green battery on the right come on I have the same one any help ??????
+Gunnar Hansen Actualy, I have send it to my friend who is doing repairs of industrial electronic equipment, and he found that one chip on the main board is broken. As he said, there are three same circuits and on that one protective diode is mounted wrong (polarity is not good). Now we need that kind of circuit, but there is not any data...
well I did try this solution, has worked for me before but now the problem continues with the gyro red light blinking twice.. what could possibly be wrong.?
I have the same problem but my hoverboard is the one with Bluetooth and lights on the top of the wheels and one of the wheels feels weird it's feels like bumps when I turn the wheel can you tell me what's the problem
+Cris Ramos Have you try to reset the hoverboard? can find video about that on youtube, but a very important point is the final step, you cannot turn off the hoverboard until the red light keep flashing for at least 8 times. Someone turn off only flashing 3 or 4 times, that may cause loss of program, then hoverboard is broken.
mine wouldn't turn on so i replaced every single part and now it works perfect. the only problem is that the battery light does not turn on and it won't charge it at all. i have tried different chargers and it just won't charge it. can you please help?? thank you
If you have a red flashing light on one side and it wont move and Recalibrate doesn't fix it... Check all plugs and wires are getting good connection (Especially the 5 wire sockets). If they are and it still don't move then it probly has a blown output fet on the side thats red. They're easy to change.. MAKE SURE BATTERY IS UNPLUGGED!! Measure the Mosfets, 6 on a heatsink per side(GDS)... Usually only 1 or 2 short... DMM to Diode, Neg on Center pin (Drain), Gate approx +1.5v, Source approx .5v. YST7575C crosses to RU6888R 68v 88a TO220 *** For the 12 Fet Mainboard Model, one bank of Fets controls one drive wheel. Do a continuity test to figure out what bank controls what side.. Each bank of Fets, are broken into pairs per thick drive wheel wire (YGB)..
I have pretty much the same problem as you, but my lights blink 2 times at once (not 4 times as yours). I have tried to connect all the wires, but it still doesn't work!
+Le Sussie Yes I have double checked all the pins, but nothing works. I am pretty sure it something else since even the blinking cycle is different than yours!
same thing to me is happening, changed the gyroscope, reconnected everything, pushed every pin, still nothing and still blinking 5 times when I put pressure on the pads ...
Le Sussie I've tried calibrating it and all I can't figure it out it had the red light but now it shut off and won't work the 2 wheels do not move or anything