Тёмный

How To Install A Flow Switch For Salt Water Chlorine Systems - Pool Equipment Installation Tips 

Swimming Pool Steve
Подписаться 69 тыс.
Просмотров 42 тыс.
50% 1

From swimmingpoolste... this pool has a cartridge filter with a Jandy 3 way diverter valve installed to allow for draining of the pool. Steve also talks about how to correctly install a mechanical flow switch for a salt water chlorine generation system.

Опубликовано:

 

1 окт 2024

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 13   
@pastoryprofetaluishiciano9045
@pastoryprofetaluishiciano9045 3 месяца назад
Very educational so knowledgeable 👍🏼
@richardanthonyperez
@richardanthonyperez 5 лет назад
Wtf u never installed a flow switch, just talked the whole time 🤷🏽‍♂️
@damondelgado4603
@damondelgado4603 3 года назад
All you have to do is plug it in and screw it in the 2x2x1/2 tee.
@counterbalancelife4305
@counterbalancelife4305 Год назад
My salt cell instructions said to place it 3 feet min distance down from the heater outlet.
@glassmanforshore7995
@glassmanforshore7995 2 года назад
The flow switch needs 12” minimum distance “after” the chlorinator to prevent turbulance in the chamber. I found out the hardway
@danalockridge8374
@danalockridge8374 3 года назад
Steve the guy that put our pump in some years ago didn't bond it. Is that the same as a ground? It can tend to make me nervous, especially when it's really wet back there
@damondelgado4603
@damondelgado4603 3 года назад
I just plumb in a tee with a spigot above the pump for water drainage.
@901math4
@901math4 7 лет назад
Hi Steve, Great video series! Quick question: Is the check valve only for heater applications or should it also be used between the salt cell and a cartridge filter for pools without a heater?
@MucaroBoricua
@MucaroBoricua 3 года назад
At 2:23, you are wrong here, Steve. I bet you just glanced at the pictures in the Aquarite manual instead of reading it. Right below the figure in the plumbing section there’s a note for the flow switch that says “If the switch is plumbed after the cell,the cell can by counted as the 12” (25cm) of straight pipe.”
@Swimmingpoolsteve
@Swimmingpoolsteve 3 года назад
That change was made in the 2018 aqua rite manual, prior to this, and when this video was filmed then cell did not count towards the straight run.
@MucaroBoricua
@MucaroBoricua 3 года назад
@@Swimmingpoolsteve , sorry Steve, but I bought and installed my Aquarite myself in April 2014. And that note was there then. Why not add a note to your video to avoid misguiding people? The rest of the video is great, as usual.
@edkhoshaba170
@edkhoshaba170 3 года назад
Thanks for all your info god bless you
@xenosagaxlt
@xenosagaxlt 8 лет назад
steve i need help
Далее
How To Install a Pentair Intellichlor Salt System
11:50
Свадьба Раяна Асланбекова ❤️
00:12
Learn Pool Plumbing with Test Tank
8:40
Просмотров 117 тыс.
Salt Water Pool No Flow Error Fix
5:50
Просмотров 62 тыс.
How to Install a Water Shut off Valve for Beginners
7:33
Wirtz pumps are really clever
12:05
Просмотров 14 млн