How to Install Fuel Pump E2059MN in 1990-1996 F-150, F-250, F-350 and 1995-1996 Ford Explorer 

Is this the same process for a 97 f250 with dual tanks? Very informative video, thank you.

The next time I change a fuel pump on a truck,the bed is coming off,i don't care.Just changed a fuel pump on a 94 F-250 and it was a pain doing it from the ground.

Well shit, this was the most thoroughly informative and video by far. Great help - thank you

I have a 1996 Ford F-150 4.9L S6 (great motors) work truck with dual fuel tanks. When I bought it the truck ran perfect on the rear tank. The front tank ran rough, stalled at lights, loss power when accelerating. I dealt with it for months. The Fuel from the rear tank started to flow to the front tank. It even moved overnight from rear to front tank for a couple weeks. One morning fuel was dripping from the front tank inlet tube. Not good and very dangerous. The fuel pump had finally gave up the ghost and the check valve was failing in it. I changed the fuel filter and replaced the OEM fuel pump module in the front tank with an Airtex 2059 bought at NAPA. We followed the instructions and the truck fired up on the first try on the front tank the very first time since I owned it. Replacing the fuel pump with an Airtex fuel pump has returned my valued F-150 work truck to new running condition. Do NOT believe the bad hype about Airtex, these fuel pumps are top notch. Thank you Airtex for providing a reasonable priced OEM quality pump, I promise you all, us working guys truly appreciate it!

Wouldn't the exposed wire butt connectors create a spark hazard??

Had to replace a fuel pump on a 99 gmc z71 once. I just took the bed off. It was so much easier and faster than dropping the tank. I have to replace the pump on my 95 f350 soon so I’ll definitely be taking the bed off again.

I just replaced fuel pump/sending unit in my 93 bronco the old one worked but was on its way out anyways.. now I put the new one in and car won’t start but it will just crank over and over..I can hear the pump prime up but idk what the deal is

Does this fuel pump have the fuel selector valve in it as well?? I have a 91 F250 the front tank is pushing all the gas to the back tank and overflowing it. It is really hard to find the right one for that because it’s a split.

pull out the front one tomorrow hoping the pump is in the tank, sorry for the misprint

are the exposed wire a spark hazard

Very nice, love the safety consciousness.

Hello Sir, I have a question. I have a 1996 F250 5.8. It only has 116k miles on it and the engine sounded really good until a few weeks ago when I put about 2 year old gas in it. I KNOW THAT WAS STUPID. it was about 10 gallons. The very next day, it was rough starting up but it ran fine once it started, however, the next day, the truck was shaking, started sounding like it was misfiring, and whatever. I didnt siphon out the bad gas, instead I out fresh gas in. The fixes I have done on it thus far are: fuel filter, cleaned injectors, spark plugs and wires, new distributor cap and rotor. and it still isnt running right. I took it to a DIY mechanic who has been a mechanic for probably 50 years and he said it sounds like the lifters. What do you make of it?

i have a 1996 ford f150 i have a problem 5.0 engine my first tank stop fulling and it over flow to the first tank but the 2nd tank no problems what is it wht cause this problem help me please aspa answer....

Yer the only guy that mentioned the "wedge"...saved me an hour...thank you!

Hi, I have a 1996 Ford F-150 USA built 5.8L truck. I have a dual gas tank and I wanted to know, if I would have to replace both fuel pumps and sending units? This is based of the fact that I feel like I'm not getting any flow of gas as well as hearing a humming sounds in the back of the truck. If there is any other information you need to provide an answer please let me know. Thanks.

Where are you located.... you can do my 96 ford f350

Thanks for video just fixed fuel pump

Thank you sir I currently working on my 1990 Ford F150 4.9L hopefully I can put in back together

Don't have time for this 😒

So, hopefully you guys with airtex are still responding. I did this, except for on my rear tank with a new pump and it doesn't work

I have 95 F250 460 and I put bad gas in rear tank it starting sputtering and losing power when I hit the gas at random moments? Any help

Must be nice mines covered in oil and rust

my pump doesnt end up flush when i put it back in the tank so i cant get the lokcing ring on what am i doing wrong

Do not use water !!! Diesel way better

I have a 1996 f150 and it has the dual tanks and the fuel pump is going out. Is there two fuel pumps? one in each tank?

I have a 1992 F-250 with a newer 460 fuel injected engine; now it does not hit 2000 rpm's , is it my fuel pump? I do not have access to a pressure tester at the moment, but do you think it could possibly be my pump? I just changed the filter two days ago and it runs a little bit better, but its still not reaching it, and I only have gas in my front tank at the moment so I haven't tested the rear tank.

Hey pretty sneaky putting that hose on with that 90° scribe. I'm going do that. Grease monkey see.. grease monkey do !!!!!

You say the vent pipe stays in position but does that stay in the filler hose or in the filler pipe

i have a 93 diesel dump truck i pulled the rear out and there was no pump just a float. I am going to pull out the front one toe rear frrd into the front tank?morrow hoping the pump is in that one. Can you tell me when i switch tanks does the rear feed into the front?

I have a 92 f150 I see that you hooked together the red and black wire but in mine I have a red black red and short black wire what do I do with the blue and short black wire I see you only connected 2 wires

I have a 1995f150 4.9l I changed my rear tank pump but never had a float on it.is that normal for that year

If both tanks on my 96 are metal, they are supposed both be 18 gallon. so ones with plastic tanks are 18 in front and 19 in back?Can you confirm this? my rear float still works so I want to replace the rear pump first, is it basically the same?

Thanks, good details that I have not seen in other video content on the same subject matter.

How do you adjust a online fuel pump to turn pump pressure down

what should the fuel pressure be on a 96 Bronco 5.8L

This is all fine and good, but what if you want to replace the pump inside the assembly ONLY? This is my dilemma. And the pump I ordered doesn't fit. Wondering if there is a new style or something to my '96 Explorer. Old one uses a shorter steel tube and connects with spade connectors, not the 2-pin plug type. Frustrated.

umm it says for explorer but your working on an f-150??

on my 1993 f150 xlt 5.0 has a 4 pin connector on the tank not a round one and I'm having trouble finding the wright one i found a 1990-1991 SENDING UNIT-W/PUMP from JC Whitney and just wondering if it was what im looking for

He didn’t show what to do with yellow wire from the sending unit!

Thank you very much for this video! My front tank went out on my '95, glad I was able to find an informative video like this, might go out and get an Airtex now :)

Thee professional. Thanks Infiniti

will this work for a 97 7.3 powerstroke?

My 1997 f250 is the same body style as the 96

Man this was so much help !! Tnx !!

thank you for the information, will be doing this in a week or so :)

Thank you for this Video.

K great that's all well and good What in the hell Is that little plastic piece it showed on the top at 1:45 1:50

My 1995 f-150 cut out on me on the way to Oklahoma.I drive it around town and it never had any issues,except a few day's prior to my trip.I was carrying a load of wood,it suddenly jolted,but that's all.Then, while on my trip w/ the load of wood-it just cut out!! I rolled into a parking lot,waited for a awhile and it started up again-no issues.So I proceeded on my trip,for about 25 miles and it cut out again-nothing no sputter,no jerking,just cut out and this time it would not restart.Now it will not restart or fire at all.Have lights,and everything else??? any thoughts?tried both tanks also.same on both.

Okay. So I've had some issues starting my 1996 Ford F250. It cranks forever and eventually starts, but the start is rough and then smooths out, and also it sometimes dies before it fully starts. I watched a another video to test the fuel pump. You turn the key to the on position and wait ten seconds, switch off for ten seconds and repeat three times. My truck starts right up, so I believe its the fuel pump. Okay so a few questions: 1. How heavy is the tank when empty? I dont have a shop or many tools, so would I be able to comfortably ease it on down, 2. Must the truck be lifted up or can this be done on four wheels?

Cool tutorial thanks 🙏

Good 👍 information!

Is a 1993 f150 fuel pump compatible with a 1994 f350?

I have 97 is it the same?

Very good tutorial.

I have a 1996 Ford F-150 that looks just like this one ( color, long wheel base ect.)

Very informative video. Helped with the installation of the Airtex on my f150. One problem though. I removed the filler hose from the tank, but not from the filler neck. The end of the hose refuses to go back on the the tank. I've fought like hell and I'm afraid to break the plastic inlet tube. I decided to try to remove it from the neck, put the vent hose on first and feed it up over the inlet tube like in this video. But I can't even get the tube out of the vent hose to do this. Help!

Isn't it dangerous to have electrical wires inside of the gas tank? LOL

About how much would this cost if done by a mechanic (I already have the pump, just need the labor)?

So; any tips or how to's when it comes to the electrical connector Not wanting to budge, in coming a part? I love how youtube never shows stugglesome situations Like That that almost all Rust Belt vehicles have.