HOW TO Install Roof Top Tent (Solo DIY) 

Thanks for watching! It’s even easer to ask a buddy for help, that’s what I’ve been doing lately! Hahaha! 😆

That’s a great idea! Thanks for sharing!

Thanks man!

Yea I do like my tent, but I do envy hard shell for their easy collapsing. So have you found any good ways to get your tent up and down?

@@natenesstv6685 funny you should say that after watching a bunch of RU-vid videos I basically settled on a combination between your idea and what roofing guys do to get shingles up to a roof. I have an issue because I have cars on my driveway all the time so I don’t want to clear the driveway just to get to a place where I can hook up a winch. Effectively I made a ramp that is quite steep and it has a straight section attached at the top of each leg giving a standoff to my vehicle. I’m in the process of fabricating a shuttle/sled that will tote my rooftop tent up to the tipping point which is just beyond the middle of my tent. I marked up a sled using half-inch plywood and runners on the sides so that it can’t fall off the tracks and the principal works but where I’m at right now is I need to make a heavier duty sled and my thought is when it gets to the top I’m going to slide in a couple pins at my pivot point so that my sled can’t slide off and I will then lift the sled into a horizontal plane to push the tent off it. I probably could’ve used 2 x 4 lumber to build my frame because I had a scrap piece of 2 x 10 and I cut it in half and it’s pretty beefy

Also I’ve made every attempt to leave my bolts attached to the tent to make installation quicker but it’s risky to leave 3 inch bolts exposed moving the tent over the vehicle so I may have to rethink that

Sounds like some good engineering, I don’t see why that won’t work. Man you should totally video and upload it, I know of several other friends who our having a hard time getting their hard shells up and down. As far as removing the bolts I did put a pretty good scrape in the roof of my Tahoe, now I remove them before I install.

@@natenesstv6685 I finished the lift sled and will be trying it out tomorrow. The hardshell tents are awkward because they have sloped sides and are heavy so it’s hard to balance them on a dolly. A key aspect to doing mine is that the cart has a 3 ft high back and a sloped base. The plan is to roll the tent up to the ramp, connect the winch, raise it up to the pivot point and lay it flat on top. If it works as planned I’ll upload it. Thanks

Man thanks for the heads up on that, I’ll look into it!

Thanks for watching. Ratcheting wrenches are what I currently use but I can’t really get my hand up under very well to work. Thanks for the idea of tent set up! I’ll put that on the list!

Thanks for the sub! And they are so much fun definitely get one!

I tried putting a winch in the attic and cut a hole through the drywall/ceiling, but my garage just isn’t tall enough.

Just get a mate to help you lift the tent onto the car roof.

The ones I use are about 14ft long

@@natenesstv6685 in the spirit of the comments section, post a video of you purchasing these 14ft 2x6's and loading them and then unloading them.

Good question, I just looked it up and found It’s about 150lbs - 68kg. I think it would be much easier to install on your Porsche!

@@natenesstv6685 ok, thanks. There is a guy driving around with one on a Porsche not to far from you actually 👍

You know thats a good call… Im actually working on another RTT project right now and I think I’ll take your advice!

Good thought! Any recommendations?