On the subject of getting the yellow wires thru the rubber grommet tube; what i did was loosen both ends of the tube from the car body. Spray wd40 down the rubber tube to make it slippery inside. Then using copper wire (from the earth of a 3 core cable) made a tiny u-hook, enough to hook onto the yellow cable end. Pass the copper hook down thru the rubber tube and hook the cable back up. A little bit fiddly but it only took a minute to do each side. I made sure to use plenty of cable ties and duct tape to stop any potential cable buzzing/rattles. The rest was easy...although I did break a couple of plastic trim fixings when pulling it apart.
@@BriGuy503Overall, I love them. The larger lights could have better fitment. There's some gaps on the top that I'll need to fill in with something. Those crescent shaped trim pieces that attach to the hatch lights don't fit that great either. All that said, buy them again. The zip tie trick was clutch. I wrapped some duct tape around those pieces so it would slide a little easier thru the wires.
Hello my friend Nice job! I installed vland rearlights too but the two from outside do not work 🤬🤬 only 2/4 on running lights but 4 work while braking,do you have solutions pls? Thxxxxxx😅😅
For the wiring? No. Fit perfect. Or do you mean a spacer? I've heard of people running a spacer on the sensor so that it didn't throw a code. I had mine tuned so it doesn't throw the code any more
I really want get VLANDs, but man…. it was such a pain in the ass to run the rear dashcam cable thru that boot in the trunk that I don’t want to go thru that again lol, is there any alternative that is just plug and play?
Seem to have a fault with mine, on initial start up everything works fine but then the driver side light fails all together after a while. Any ideas or advice?
Only 1 of them worked. They are wired up for the euro gti. You have to rewire one of the reverse lights. I havent done it though. Pretty sure there is a video somewhere on RU-vid about it. I saw it once before
@@BriGuy503 thanks mate, installed mine today, and was wondering if I had gone wrong somewhere haha. If you happen to find the video could you let me know? Thanks a bunch for the reply