Between this and your removal video, I was able to switch out my factory carb on my 88 b2200. I found some intake manifold damage and swapped that out too. Now, that kitten purs. Thanks for the high-quality videos! Breaking them up into sections really helped me find the parts I needed in the garage. Keep up the good work!
Hey Brian, I'm the proud owner of a 84 B2000 with only 36,000 miles on it. Show room condition. Having an issue with the Vacuum amplifier up on the center of the firewall. It has power to it and a ground, but also a red wire with a female bullet connector about 18 inches long. Would you have any idea where the red wire goes to?
Sounds like an awesome truck! I’m not familiar with the previous gen on the Mazda since I mainly deal with the 86+ models but feel free to reach on instagram with a picture of what you have, I might be able to find it on my repair book
Great videos !I have a question, theres 3 line coming from the fuel tank to the engine bay , one for fuel , another for return , and what is it the 3rd for?
Hey brian, do you know if this carries over to a b2600i? it's already got a weird ass dual carb lol i wanna give it a regular single weber, any info on that?
Both of my trucks are running without all the wiring I removed. You didn’t cut anything right? I’d trace the wires on the starter and make sure it’s all plugged in right, check grounds and power wires as well. I had a bad ground one time that was making the starter act funny
Whats up bro iv had my weber on for awhile already been running a small filter on top of the valve cover like you but mine is spitting up oil and getting under the hood all dirty what u think i can do ?
There's a plate with a silicone gasket in the underside of you valve cover. Sounds like your gasket might be trashed. Pull the valve cover and peel the old gasket off and use high temp rtv. Just make sure you get all the old gasket off and the surfaces are clean.
The distributor did you have to change it cause I just got an 88 b2200 and they have a dam 26/27 Webber on it and the distributor has no vacuum advance 😑😑😑
Glad you figured out what was wrong, might just need to find that part and replace it or block it off, I seen some people run it without that line but I'd recommend adding it
A genuine Weber has a w and Weber stamped on the top and Weber going down up and down on the body I believe he got a knockoff Weber there a lot cheaper but they wear out fast and can cause you problem it's better to spend a couple more hundred dollars and get there is a RU-vid video on telling the real from the
We had a small glitch on shipping. I made sure we took care of it. Go ahead and give it another try, if you have more issues, email me at flakegarageyt@gmail.com and I'll make sure I get it taken care of. Thank you so much for your support!