How to make a 4-bladed prop for buzzbait. 

I don't have a 1/2 size blade now, but I hope to add several more sizes in the future.

just use square holes instead of round ones for the prop, it will clatter on the shaft and make a lot more noise

ハンドニブラーというようです

@@im6456 有難う御座います。

@@necodazai1337 to

ありがとうございます。ぜひ挑戦してみてください😃。ドリルで開ける穴の大きさは、使用するワイヤー径によっても変わってくるのですが、おおよそ1.5ミリから2ミリほどです。もしブレードがスムーズに回転しない場合は、穴のサイズを少し拡張して調整しています。 そして、ワイヤーは直径1ミリから1.2ミリの硬質ステンレス線を使っています。通常サイズであれば1mm、大型サイズや強度が必要なバズベイトを作る場合は1.2mmで作っています。

@@haru834 返信ありがとうございます！道具を揃えて作ってみます(^^)

Thank you for the question. How to make a lure body is shown in this video. I'm making it slowly in the video, but if all goes well, you can make it in about 5 minutes. *How to make a homemade buzzbait: ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-WwKWmdOpz6A.html .

Thanks for your comment. The jump frog project is coming along nicely, although it will still take some time to complete. *Photo of the prototype: twitter.com/Haru834_Y/status/1432381393540026371/photo/1

Thanks for your question. My setup method for the buzzbait is to crimp the rivets onto the shaft. I crimp the rivets to the shaft, adjusting the rivets to maximise the area where the back of the blade contacts the rivets. After five minutes of turning the blade. If you hear a louder, squeaky sound, your buzzbait is successfully set up👍. If I want a higher level of set up, I use a file to rough up the surface of the rivet.

Hi, thank you for your question. This tool is called a "Nibbler" or "Metal Nibbler". A high-end brand costs about $50, but I'm using an inexpensive one that costs about $15. It can cut metal plate into squares, so it's useful not only for making buzzbait blade but also for making a blade bait.

@@haru834 Thank you for the useful answer mate🙂 Your videos are very educative, thank you for making☺