Just some knowledge i have discovered. Stencil film 0.4 setting - i use this for backed stencil film (ormask) that i would normally use for templates etc when airbrushing but it also works for mylar. 2-5 mil worked fine on standard depth. 5-9 mil was half and half on if it worked on standard depth. I got away with standard on most but the deep cut also worked better on some of my designs. I found the more complex designs were trickier but either did some test cuts first to check, or ran the extremely complex pattern option rather than moderate complex. I did notice while watching this that there is also a mylar option in the materials so will have to try that aswell now on some different thickness mylar
Hi thanks for the video! One question I had was when you used your explore to cut the 6 mil mylar, how many passes did you need? Just 1 or did you have to do multiple passes to cut it clean? thanks
Somebody said use deep cut blade and the custom setting for magnetic sheet with the most pressure. Did you figured what settings to use on the maker for this ? I have a maker too
sorry but i did not get much from this. what was the thickness of the mylar? why did it not cut? i was waiting for a solution to your problem sorry for the negativity but i feel you needed to address the problem
I am also having issues with the maker and stencils. Some cut and some are stuck in the stencil material even after 4 passes with the maker. So I found another video showing to set your own pressure to the max at 374. I am going to give that a try. I am using 6mil with the fine point currently. Anyone else figure out why maker is acting up on stencils?
I am new and was frustrated when cutting my stencil with the mylar this morning. Glad I came across this video. Seenthroughmylens; where do you adjust the pressure to 374? Thanks,
I just bought some mylar 10 mil from Amazon because I read some where that was the correct thickness for reusable. Not having any luck cutting it. Do you ha suggestions cutting 10mil or should I just buy thinner mylar? Thanks
Can we search for images to make stencils like the fonts? Not all images in DS can be made into a stencil. Did you try increasing the blade pressure on your maker? Thank you for this video tut.
I was so excited to find a video that explained how to make a stencil on the Cricut Maker, now I feel disappointed in the machine because it could not cut the mylar, wish I had bought the less expensive explorer😭
I've since switched to a thinner mylar that my Maker will cut ok. And it may just be my maker. I've heard others say they're maker has more pressure than their explore. It definitely taught me no two Cricuts are the same! I would get 4mil mylar and try it out.!
I emailed them and they had me reset the machine and do a few test cuts. I'm not sure what was wrong with it that day, but it was frustrating for sure!
@@DailyDoseofDIY After you reset the machine, did the test cuts work? If so, did it work with the poster board setting, highest pressure, and the deep cut blade? Or did a different combination of settings work?
Yes but you have to use a small small amount or it will pull off your paint when you take the stencil off. Also it won't be a full-proof seal so you'll still have to be careful