How To Make Heavy Brackets For Gas Door Shocks 

This is perfect! Thank you. I'm putting these on my mobile bar trailer build and having the hardest time! This is the solution!

Great... Thanks for this share....

Perfect video🎉 I’ve been searching for a week now!!!

Here is the link for the struts we bought on Amazon. 23 inch 150 LB Gas Prop Struts Shocks with L Mounting Brackets, 23" 150 Pound Lift-Support Gas Springs for Heavy Duty RV Murphy Bed Trap Door Floor Hatch (Super Strong for 130-150lbs Lids) a.co/d/5FiYbJX

Awesome job. I am actually doing the same thing right now for a shed bar. How did you know exactly where to place the brackets so that the door opens to a 90 and closes?

I got dizzy watching this and trying to see what you actually did..

I think the bracket on the window should be "off" the top hinges between 50 - 75 % of its length to the front (you have it less than 25%) in your way it is too much pressure ( upwards ) on the hinges when the weight of the window is pushing down at the very front of it and the frame is not resting on the struts, if you do the 50 - 75% the weight it would press the hinges down not as in your case up and the whole window would be more comfortably resting on the struts ( less pressure weight ) since more it would be on the hinges ..all the best to you

Where did you buy the flexible seal at the bottom of the hatch

Great solution! Where did you buy the fitting the strut attaches to?

How did you cut the metal pieces?

Which brand is the strut?

is there a certain angle they need to be mounted? i want to do this for a garage door :)

Where do you buy your hardy board? Its so expensive.... i can get sheeting and siding for a a ⅓ of the cost of hardy.

Dangerous !