I was searching for this type of video for years and finally I found it. I am just student and I cannot afford mini drill also so it means I just need to buy 1 bit and that's all 😁 thankyou very much bro. I have also watched your all other videos and they were also soo much inspiring to me. Thankyou again and may God bless you.
This has been said already, but after watching just two of your videos I can't thank you enough for the content! This gives me some confidence in a future custom!
I noticed that some drill bits are either not wide enough, or too big on some vehicle's. I prefer to use screws to reassemble afterward. They look better.
Thanks, I'm remodeling some cars for the Gaslands tabletop, so I needed to know how to carefully remove the chassis for aging, painting and modding. I think I will be using superglue to reconnect, though.
Only thing I would recommend is Dry Lube on the bits & the posts when tapping. There is a heat build up that can cause damage to the chassis (especially plastic), diecast post and the bits themselves. Use the oil it's a cleaner job.
Great video! Question: How come you use the 10 mm bolt to make threads and then the 6mm and not just use the 6mm screw right from the begining and be done?
Hopefully this works. I have around 10 cars with bent axles and need to fix them. I have around 200 vehicles and have been collecting since I was 4. A decade later, I have A LOT of cars.
THABK YOU SO MUCH! I'VE LOOKING FOR VIDEOS LIKE THIA BUT NONE OF THEM WERE GOOD, THIS IS AMAZING ITS GONNA HELP ME SO MUCH WHEN I WANT TO CUSTOMIZE MY FIRST HOT WHEEL! THANK YOU SO MUCH, YOU EARNED A SUB!!! 👍👍👍👍👍
I have a couple of HW retro entertainment Deloreans...I'd like to get the rivets off so I can put screws in which would allow me personalisation to swap the chassis on the cars and get in them if I needed to...though I'd like a professional job done on them (not by an amateur like me) if I could pay someone for the work.
I think commenting on your very first video won't be a way to receive an answer. But I think this is a video with best editing you've ever made so I just wanna ask that what software did you use to create those nice graphics and subscriptions?? Hope you will answer! And just want to say that I love your works and please keep doing them!!
I’ve just recently tried doing these steps but I feel like I’m doing something wrong. I’ve used the exact same tools and screws. After I drill using the 1.8 mm drill bit, the screws just seem to just go straight down. Meaning it doesn’t screw in or tighten. Any advice will help. Thanks.
does this apply the same for other brands, for example the car im trying to open, a subie impreza wrx from majorette? im using a drill but if i find one, ill use a hand drill (skrewdriver lol) great video!