Expand this… so you have your bag of disassembled series 7 braun shaver parts because you disassembled the shaver head. This video will show how to reassemble a braun series 7 5671-74 head.
Don’t like, don’t subscribe, don’t watch the whole video, go right to the end.
Don’t watch the video -
Here are the tools (of ignorance) and steps involved .41mm wire was used here, but .33mm should work also.
Pliers to cut the wire, and
Pliers to set wire and
Pliers remove the wire and
Torx t-6 screwdriver and
Torx t-8 screwdriver.
Install the spring so the bend of the bent end sticks out the opening at the top of the head, using pliers pass the wire through the bend to hold the spring leg, do the same to the other leg. Repeat for the other spring.
Snap the bottom the head in place, making sure the ‘antenna springs’ on this part are pointing in the direction of the release button.
Install the head onto the ‘tuning forks/arms’ of the motor - making sure the arms are in their sockets, install the ‘L’ brackets in place, on top of the spring bends. Screw down the ‘L’ brackets with the t-6 screwdriver - before tightening completely - pull out the 4 wires using your other pliers.
The head is now assembled.
Now reassemble the rest of your braun 5671-74.
I expect to see your video, on how to fix the ‘lock’ button. Lock button on the shaver in video does not appear to lock anything.
This series 7 was pickup at a second hand shop with a bad clipper (would not lay flat )(and bad lock button?)- RU-vid showed how to fix that [the legs of the clipper springs have to be in their place] as show in this and other videos. Surprisingly it was fully charged.
25 мар 2022
