How to remove Porsche 911 bumper (997 DIY Tutorial) 

The rear bumper is easier. Just pop off the tail lights, undo the fasteners exposed with the engine cover open, then get a few screws under the rear wheel wells and lower portion of the bumper. No wheel liners to mess with nor. Lifting of the car.

You can also look at my step by step rear bumper directions on Rennlist Forum 997.

Thank you!

Glad it helped!

It's an oem lip from the 991. I picked it up from Suncoast I believe. I have a video on it.

You just reinsert it and can tap it back in with a hammer and a socket extension.

No difference, but I don't have the full aero kit (lip and wing)

It's an aero kit bumper with the original lip from the GTS. It does not fit the regular 997 bumper unfortunately.

Which clips?

@@CarFanatic thank you for your reply - mine is actually a gen 2 car just like yours - all the first steps are fine to remove the wheel housing and clips for light washer and side lights - even in the front tub behind the bumper that is fine - but the clips at the side - I just cant work that out - because you cant see them - so heaven forbid how on earth do you put them when putting the bumper back on? thank you

That was the lip off the 991. I just screwed it out. I have another video on that if you check out my channel.

One like this: amzn.to/3Ug391u

@@CarFanatic Thanks, great channel btw. I recently bought a 997.2 and have learned a lot from you.

Ha no way. The stock brakes with track pads would be more than enough for what I'd ever do. Thanks for watching. Hope you are subscribed!

Car Fanatic yes- been following since I owned a 997.2 back in 2013. Now have had - 991.1 for years in San Diego. Cheers.

I opted for the PCCBs when I ordered my 06 S cab. At 126,000 plus miles and still on the factory installed pads all around. Pads have 7mm remaining-about 60% remaining.