How to Replace a Fountain Submersible Water Pump - The End Grain Workshop 

I finally understand that the old cable needs to be cut at the pump point. For over a year I could not get my brain around it, until I say your video. Thank you!

great job, very simple way to teach. this was very helpful.

new waheed pendu ki taraf se aapko aur aapke chahane walon ko dher dher salam pesh karta hun shukriya kya dost aapane video taiyar ki hai बहुत-बहुत khubsurat hai shukriya mere Dost

Great video!

You have to do everything step by step and you will succeed. You must disconnect everything from PC protection. Thank you, Tutorials Buddy

Liked the video especially how you went through your own particular set up! I am assuming that the electrical in the base of the fountain is at a height in which water cannot flow in it..Great vid thanks!

thanks for video. very helpful. bought new house and need to replace fountain motor. still trying to figure out how to disassemble for cleaning. i removed the caulking and tried to spin the top off but the top piece is locked in place while the lower pieces can spin freely but cannot remove because of the top piece

Is there a workaround if the new pumps power cord head doesn't fit through the pipe it needs to fit through?

Thanks for the great video! We have a similar fountain (and pump), but I have an off-topic question. By chance, do you have any recommendations for keeping the door in front of the pump closed? We have some curious raccoons who come by often, and they push open the door, and have even pulled out the pump! I need access to the pump, so I can’t seal the door. I’ve tried wedges, wrapping rope around the base/door, but they eventually still open the door! Just wondering if you have any ideas? Thanks again for your informative video!

Thank you for the informative video. In the video I thought you referenced that the replacement pump had a 16' cord but the link to Amazon shows one with a 6' cord. I am trying to find a replacement pump with as long of a cord as possible (16' would be great). I appreciate any advice. Thank you.

Is it the same pump that do both the drainage and the pumping to the pool?

What about the cut out why don't it let water to the in side off the fountain

Cannot believe you didn't clean out the basin of the lower tear. It was filled with all kinds of debris that could clog and damage the new pump that you just put in... It makes the water look nasty🙄