JC250 in the video I use a very small flat head screwdriver and hammer to punch them out. Be careful you are on the bearing and not the center aluminum. 👍
Neil Camara Most people that sell motors sell replacement bearings. First you need to know the size of the bearing which is measured in millimeters. Measured in width and height. So how many millimeters the bearing is across and how many millimeters the bearing is tall. I have some 2306 brother hobby motors. They are 9 mm wide. I’m not sure about the height. I will pull one apart this evening and get back to you on the height. Thanks
@@reaganleejobe I found out the size of my motors yesterday. It's 9x9x4. I ordered 10 pieces for a total of $9. Not bad. It will arrive on May 12. Thank you!
RED loctite for that? I guess if you never want them back out. I tried this with some eachine motors, they use some weird super thin locking ring in there which made tapping out the original bearings nearly impossible without an actual press, you just about almost destroy the stator doing so.
