How to Replace Blend Door Actuator on Dodge Avenger 

Thank you for showing what this actually does. Been upgrading my car and i think this is what my problem is we'll see!

I watched several videos about this and yours was the most complete!

Thanks for the assistance on this. I did the two on the passenger side a couple years ago but they were easier. One comment is that I found it helpful to take the cover off my steering column, gave me a better view and another place to work

Out of all the vids I watched on this ,your vid helped the most. I did subscribe. Keep up the good work fam.

Good vid. Do you have one on changing the other two

Thank you there are 3 of these on a 2012 Dodge Avenger and I replaced al 3 and my a/c and heater works great

good video. couple things: on my 13, you have to take off the side plastic piece, kind of by the door frame. then a 20 torx bit for one screw. at that time you can pull off the plastic piece that is where your knees sit. in the bottom corner there is one plastic round clip to remove as well. I found it easiest to push the seat all the way back, and lay on my back while looking up. and use a short stubby phillips screwdriver. you have to install the white arm first. the top part slips onto the gear, and the bottom piece clips into the "slotted" rainbow looking piece. it sits right in the middle of the slot. I had to clip in the connector BEFORE screwing in the actuator. it would not clip in otherwise. make sure to listen to ALL THREE actuators. I had 2 bad ones.

Thank you so much your so much more informative than others. Thank you again.

Good job on showing the process, Tobias. Thank you.

So is the part defective? If yes, what is the best replacement part to purchase?

Having this same problem but it's both vents on the driver side of the car (the left vent above the radio and the vent left of the steering wheel). I'm trying to figure out which part I need! Someone on a forum also said to try changing the cabin air filter because theirs was gunked up and it caused the left air vents to blow warm so I'll try that first as it's the least expensive thing to do and mine hasn't been changed in quite a while.

Thank you sooo much bro ! Same problem same car man grate video

Im having trouble reattaching the arm. Im not sure if i have it in the right position. Any suggestions?

I replaced both that were ticking but still warm air .. i have a new ac compressor too and the ac line is frosting… any advice?

Are all 3 actuators the same part? Advanced auto has it labeled as “main” but mines the one all the way to the right

Thank you.. very helpful instructions

It's easier to reach if you go in through the driver door and lay down on your back across the seats (and that @#$% e-brake lever). I fumbled around until I did it that way. Laying down across the seats I was done in, like, 5 minutes.

Hey cool video. Q? U said there r 3 of those r all 3 the same part? Or the other 2 that are located under the glove department r different?

Did you need a scanner or any process with the buttons?

2 years later but thank you! Everyone kept telling me I only had 2 and they are behind my glove box even though the noise was clearly behind my steering wheel!!

This was super helpful because I had no clue the third actuator was in that location behind there wheel. I also thought there were 4 not 3 actuators.

Thanks is lot help for me

What setting did you change to test the arm to see if it worked?

Not sure if you know why but its worth it to ask, but my top vents won't push air out at all. If I put it on my top vent setting I feel it on my feet mostly and maybe a small amount in the top vents. It's still cold air it just won't come out tho.

My panel isn't popping out like that. I can't find any videos on a 2013 avenger.

My click click is coming from the right side of the radio by the vent, how do I get to it? ive been told blend doors go out quiet often.

Great video👌

Worked on my 07 chrysler sebring.

Great video, very helpful. Installing now. Lyk if it goes bad

Que pasa si solo eliminas el actuador o alguien lo ha reparado

Buen video 👍👍👍

😊❤

How's the repair today? Does the blend door actuator work well ?

Muy bueno grasias

Awsome

I was able to cheat it and replace the actuator without removing my trim, only to find out the heater core is the cause of the drivers side heat ://

Muy bueno gracias

My car blows cold air but when I switch it to heat it stays blowing cold air

Only thing I didn't like was you spent half the video talking (3:27) before getting to the nitty gritty.

Tip, don't talk so fast in your videos.. my ears lol

You have GOT to be kidding! You show NOTHING ACCURATE, about removing the cover. There is NO WAY it just came off like that!!! In addition, it takes a T20 AND a T15!