How To Replace The Clutch On a 99-04 Ford Mustang 

Hey Guys I've noticed this video has helped a lot of people out and I'm very proud of that if you guys could I've noticed this video has 20k people that's watching and 90% has not subscribed or like the video if it's helped you in any way please take 2 seconds to like and subscribe so I can keep putting these videos out . Thank You All ❤

Great video...thanks! I just replaced the clutch and rear main seal on an '03 with 3.8L. I found I had to remove the shifter 'fork' out of the transmission too. This made it easy to slide the tranny back. I left the driveshaft in the trans so no oil spilled. I used a ratchet strap to hold rear of driveshaft up. As he said in the video...remove trans from bell housing and then you can leave the exhaust system installed. Cheers

Good video bro

I just worked on someones mustang and this video was great !! Appreciate it

Great vidéo ! The infos I needed. Thanks ! How high the car must be from the ground for good clearance ?

So we just aren't going to address the pilot bearing or the rear main seal?

You don't need take it off from the bell housing take the whole tranny of

Outsyourway

"Make sure it touches no metal" :puts it on the same side as the alternator

Wow, this video wasn’t helpful. I was looking for a video on how to replace a clutch and it just shows the removal and not the replace part.

Your hands don't match your voice