How To Replace the Starter Clutch on a Yamaha Warrior 350 

Could not have done it any better bro, nice job i done my starter clutch on my warrior 2 not 3months ago honestly wish'd ur video was out to follow step by step. KEEP up the good work Bro👌💪

January 16th 2024 very educational

Love how you skipped the part I needed to see lol 😢😂

Thank u! Very good video about to try it myself got it parts in today!

When the starter clutch is bad will the machine have spark or no spark?

Nice job mate

Aren't them Star bit screws need Lock Tite on them threads so they don't get loose through time ? And Plus I noticed it seems pretty difficult to realign the setup with that Lock pin that sits in the shaft itself

I've gotten ahold of a Yamaha warrior but notice i am missing some parts there is a shaft that the gears turn on that turns when starter spins and cant seem to find the name of the shaft to locate to purchase you can see it clearly at 8:08 in your video can you help thanks a bunch.

Buenas tardes, tengo un Yamaha warrior 1995 con el mismo problema, mi pregunta es que marca de respuesta recomiendas porque en Amazon hay muchas marcas y no sé cuál elegir,

When you pull the nut in the middle how did you slide out the thing in behind it? I’m struggling bad 😂

Nice job! Got any ideas about a broken case saver for the sprocket? Can't seem to find anyone out there that makes a case saver for a broken case!

Will this be close to the same on the wolverine 350? I know the cases are different but is it kind of close? My starter clutch is toast.

I had a free spinning sound , I replaced the starter , and starter clutch and still sounds like a free spin . Any help ! ? I checked the one way bearing before install it looked fine . Bike also starts fine if I bump start it motor sounds good

Will this one way bearing cause no compression?

So I got everything off and can’t get the star bits off the fly wheel. Do I need a tool for some good leverage? Also I’m confused on what way to put the new starter clutch in.

The one part I neeeded to see you edited out I can’t even put mine back on and you didn’t show how to

Do you just slide the flywheel on? Mine keeps attaching itself to the stator when I put the cover on like the flywheel isn’t tight enough

What îs the correct way to put the bearing ? with the Arrow to the engine or to the flywheel?

What kidn of oil goes in there?

Every time I try to put the stator back in the motor the stator pulls out the flywheel and rear gear because of the flywheel magnet??

So I rebuilt warrior 350. Put a new piston from amazon in it because it had a 5 star rating. Crankshaft spins fine, new timing chain and valve clearance is set properly. Once I install cam the motor only turn half way and stop forward or backwards. No spark plug is in it so it should spin freely but it’s not. I took the cam back out and noticed a deep scratch inside head like cam is too big to spin but it’s the original cam and was spinning fine before the rebuild. TDC is perfect so idk what else it could be to cause the original cam to not turn. Can someone give me suggestions please?

How come you didn’t start it??

Does anybody have the torque specs for the bolts holding the stator?

When you replace your starter , how much oil do you need to add back b4 you crank it over,??

Did you have to drill your bolts out that hold the one way together

why are the wires called at 5:16 mine are shot i need to replace them but don't know the name

Hi, what is the name of the tool to remove the clutch ? Thanks

Start it?!

What size MM is the flywheel puller?