How to Reset Ecu and Sensor Eot Beat 2021 Manual
Complete guide on how to reset ecu ecm sensor eot or ect and setting beat mode 2020 2021
For mode 1, the motor is used in the altitude range of 0-2,000 m above sea level. Then, 2,000-2,500 m above sea level, for mode 2. Continue Mode 3, an altitude of 2,500-3,500 m above sea level. Finally, above 3500 m above sea level the motor is set in mode 4.
#resetecubeat2021
#reeteotbeat2021
#cararesetecubeat2021manual
#resetinjeksibeat2021
Manual Injection Research Method
HOW TO RESET BEAT INJECTION, can be done on all types of Honda motorcycles
1. research ecm ecu
2. research eot or ect
3.mode setting
ecm research stage:
1. ignition off
2. install the dlc jumper
3. ignition on
4. Count 5 seconds the tongs are removed from the dlc
5. after removing the count of 5 seconds, plug it back into the dlc
6. then the ignition is off
eot research stage
1. the clamp on the dlc is still installed
2. ignition off position
3. Install the 2nd snap on the eot sensor
4. then contact on ON
5. then the jemperan on the eot sensor unplug count to 5 seconds
6. then the contact is off
7. then install the eot sensor again
mode setting stage 1
1. the clamp on the dlc is still installed
2. the ignition is still in the off position
3. then the gas is pulled until it is full
4.then the ignition is on
5. Wait for the mile code until it flashes before releasing the gas
6.and see the mile code should flash 1 time
7. after finishing the ignition off and the dlc jumper is removed
mode setting stage 2
1.j
overhang dlc still installed
2. the ignition is still in the off position
3. then the gas is pulled until it is full
4.then the ignition is on
5. Wait for the mile code to flash before releasing the gas up to 2 times the gas is stuck
6.and see the mile code should flash 2 times
7. after the ignition is finished, the dlc jumper is removed
22 авг 2021
