How To Set Up a CURT Weight Distribution Hitch 

Thank god I watched this a few times before I picked up my trailer today. Dealer was absolutely useless.

Thank you for a very informative video. I was given most of one of these systems and your video shows the parts I needed to bolt to the trailer frame. Now that I have everything I need I can get this hooked up.

Just had one installed thank you for the info I understand it better now then when the sales and install tech showed me the how to's.

Best video I have seen that explains how they work.

OK ; i ONLY need to see that a few more times; it IS beginning to make sense... 👌👣

5:00 he has a chain link jammed into the link that is being hooked up,do not do that

Thank you for the video. Wondering where you can purchase different brackets to avoid the propane tanks?

I don't understand this my instruction said the top of the ball should be the same height as the trailer hitch where the ball goes up in it the other videos I watch said the same thing with the ball height the same as the inside of the coupler hitch height could someone reflect on this please

Why is the professional trapping the link of the chain above the hook. I’m watching this to learn and this is not helpful.

Wring instructions on before and after height calculations. Not physically possible to get both front and rear distance within 1/2" of unloaded height. Simple physics will not allow this if you are towing a reasonable amount of weight.

What’s the torque suppose to be

Did everything that was explained. Still losing over 1”. Went above coupler 1.5”. Tried dropping my hitch a couple of holes down and still same results. What am I doing wrong? Should I go higher instead. Frustrating. Also leveling trailer should be on the front A frame or the frame that holds the sleeping compartment? I ask because they are different angles. I would go off the center frame but maybe I’m wrong as well. Please help

How do you know which chain link to use

The 1/2" rule is BS. That depends on a lot of factors. Spring rate, wheel base, tire sidewall softness, etc. On my 2021 F-150 with 18" wheels, tires at 40 PSI, 157" wheelbase, 7100 package, 800 lbs tongue weight, I was able to get the trailer completely level, 1" sag in the rear, 0 raise on the front. If I add a link, the rear sags more just to get the front to raise 1/2", but the trailer becomes 1" lower in the front than at the rear. That puts more weight on the front axle of the trailer, more weight on the hitch, more weight on the rear axle of the vehicle, and less weight on the front of the vehicle. Everything you're trying to avoid with a WD hitch. This creates a less stable and less safe setup all around. While 1/2" raise isn't much, 0 raise is better. And no way was I going to get this truck to only have 1/2" sag in the rear. It's just not possible no matter how much I play with the hitch angle or the hitch height.

I got tired just watching the video.

I don’t understand. If the hitch weight is distributed, shouldn’t that raise the back end of the truck"

Not trying to say anything bad about this just opinion. For the amount of work installing this I would just opp for a fifthwheel js🤷‍♂️

This looks strange

⁰)

Terrible demonstration..... poor video... too many short cut... terrible..thumb down

WD hitches are bullsh*t. They DO NOT distribute weight. What they do is create a torque force. This force acts to counter the downward force of the hitch and create a resultant forward force. [proven by simple vector analysis] This means your frame is taking MORE force than otherwise. And, if you are not careful, you can easily overload your front axles, especially when braking. A WD hitch is a torsion hitch. Proof: no torsion bars, no WD effect. A WD can in fact create dangers in emergencies.